User manual SHARP QT-95H

[. . . ] refer internal service to your local SHARP service facility. Q Use the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. Q If the unit does not work properly, set the FUNCTION switch to STAND-BY and then to ON again. q In case of an electrical storm , unplug the unit for safety. [. . . ] selector adjustment: Slide the selector with a screwdriver to the appropriate voltage number. (AC 110 - 127 V or AC 220 - 240 V) AC plug adaptor: In areas (or countries) where an AC socket as shown in illustration 2 is used, connect the unit using the AC plug adaptor supplied with the unit, as illustrated. The AC plug adaptor is not included in areas where the AC wall socket and AC power plug can be directly connected (see illustration 1 ). Notes: q If the unit will not be used for a long period of time, remove the AC power lead from the AC socket. Q Connection of the AC power lead to the unit disconnects the batteries. Using other power leads may cause an electric shock or fire. Insert 10 "D" size batteries (UM/SUM-1, R20, HP-2 or similar) into the battery compartment. Q Installing the batteries incorrectly may cause the unit to malfunction. Replace the batteries when they become weak This may occur even though radio broadcasts are audible. Notes: q Replace all old batteries with new ones at the same time. Q Remove the batteries if they are weak or if the unit will not be used for long periods of time. 2 Load a tape into the cassette compartment with the side to be erased facing up. S Mixing from a microphone s Recording of mixed sound and other sources to a cassette tape You can listen to mixed sound from an external microphone and other sources. You can record mixed sound from an external microphone and other sources. To protect the speakers from shock noise and to avoid disturbing noises, set the VOLUME control to minimum. To protect the speakers from shock noise and to avoid disturbing noises, set the VOLUME control to minimum. connect the microphone to the MIXING MIC socket. Load a cassette into the cassette compartment. Q Place the microphone about 10 - 15 cm (46") away from the source. Q If howling occurs, lower the volume or move the microphone as far as possible from the speakers. Caution: When not using the microphone, remove the microphone plug from the MIXING MIC socket. Note: To record the microphone signals only, load a cassette into the cassette compartment, set the FUNCTION switch to TAPE, and then press the RECORD q button. [. . . ] S Cleaning the tape-handling s Cleaning the cabinet Periodically wipe the cabinet with a soft cloth parts Q Dirty heads, capstan or pinch roller can cause poor sound and tape jams. Clean these parts with a cotton swab moistened with commercial head/pinch roller cleaner or isopropyl alcohol. Q After long use, the deck's heads and capstan may become magnetised, causing poor sound. Demagnetise these parts once every 30 hours of playing/recording by using a commercial tape head demagnetiser. [. . . ]