User manual SHARP SF-2014

[. . . ] For quick reference during copier use, keep this manual in a handy location. The SF-2014 can be used as a laser printer. The AL-1020/AL-1220 /AL-1521 can also be used as a laser printer if an optional printer upgrade kit is installed. This manual describes only the copier features. [. . . ] 0 e OFF 0 e OFF * 1 e ON * 1 e ON 4 Special functions Factory default settings are indicated with an asterisk (*). 5 Press the print ( ) key. The right-hand number in the display will be steadily lit and the entered value will be stored. To change the setting or to set another mode, press the clear ( copier will return to step 2. ) key. The 6 Press the light ( ) or dark ( ) key to return to the normal copy mode. DISPLAYING TOTAL NUMBER OF COPIES Use the following procedure to display the total number of copies. 1 Press the clear ( ) key to reset the display to zero. 2 Press and hold down the clear ( ) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits. Example: Total number of copies is 1, 234. 27 5 SUPPLIES AND USER MAINTENANCE Be sure to use only genuine SHARP parts and supplies. This chapter describes how to replace the TD cartridge and the drum cartridge. TD CARTRIDGE REPLACEMENT The TD cartridge replacement required ( ) indicator will light up when toner is needed. For more information on purchasing the TD cartridge, see OPTION AND SUPPLY PART NUMBERS AND STORAGE on page 44. If copying is continued while the indicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below. After the copier stops, it may be possible to make a few more copies by taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge. q During long copy run of a dark original, the ready ( ) indicator may blink, the indicator light up, and the copier stop, even though toner is left. Close the front cover and then the side cover by pressing the round projections near the side cover open button. The drum replacement required ( ) indicator will go out and the ready ( ) indicator will light up. When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged. 5 Supplies and user maintenance 30 USER MAINTENANCE USER MAINTENANCE Proper care is essential in order to get clean, sharp copies. Be sure to take a few minutes to regularly clean the copier. Before cleaning, be sure to turn the power switch off and remove the power cord from the outlet. Do not use thinner, benzene or other volatile cleaning agents. Doing so may cause deformation, discoloration, deterioration or malfunction. Cabinet Wipe the cabinet with a soft, clean cloth. Original table and original cover Stains on the glass, cover or SPF roller will also be copied. Wipe the glass, cover and SPF roller with a soft, clean cloth. If necessary, dampen the cloth with a glass cleaner. Original table Original cover SPF roller 5 Supplies and user maintenance 31 USER MAINTENANCE Transfer charger If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the charger using the following procedure. 1 2 3 Turn the power switch off. Ensure that the bypass tray is open and then open the side cover while pressing the side cover open button. [. . . ] Please be sure to retain the original packaging materials in order to facilitate shipment. The shipment of the defective unit will be at your expense; please be sure it is insured and packaged securely. Upon repair of your unit, Sharp will promptly return it at no cost to you at any U. S. location. What You Must Do Your Product is designed to perform with a minimum amount of user maintenance. [. . . ]