User manual SHARP SF-2218

[. . . ] In some areas, the "POWER" switch positions are marked "I" and "i" on the copier instead of "ON" and "OFF". The symbol "i" denotes the copier is not completely de-energized but in a stand-by condition at this "POWER" switch position. If your copier is so marked, please read "I" for "ON" and "i" for "OFF". CAUTION: For a complete electrical disconnection, pull out the main plug. [. . . ] The entered parameter number will blink on the right side of the copy quantity display. For example, to change the setting of the auto power shut-off mode to "15 min. The right-hand number in the copy quantity display will be steadily lit and the entered value will be stored. 6 To continue with other user programs, press the C key and then repeat steps 2 to 5. 4 Auto power save control 5 Stream feeding mode 7 Sorter bin access mode 10 Auditing mode 11 Account number entry 12 Account number change 13 Account number detection 14 Number of copies per account 15 Resetting account 20 Setting the auto power shut off mode Factory default settings are indicated with an asterisk (*). Auto power shut off time versus program 20, 4, 3 settings 20 0 4 0 3 1 to 6 Results Auto power shut off mode is not available Auto power shut off time is set manually using program 3 0 oder 1 0 or 1 1 1 to 6 Auto power shut off time is set automatically by the copier Press the TRAY SELECT (T) key for more than 5 seconds. Enter T a program number (10 to 15) using the 10-key pad. If the auditing mode is enabled, copying is limited to operators with an assigned 3-digit account number. A maximum of 20, 3-digit account numbers can be assigned. To continue with other user programs, press the C key and enter other program numbers. If the number of accounts has reached the upper limit (20), "11E" will appear in the copy quantity display. Enter a 3-digit account number using the 10-key pad. Any 3-digit number except 000 can be registered as an account number. If a number that is already registered or "000" is entered, the number will blink in the copy quantity display. Repeat steps 1 and 2 for other account numbers. To continue with other user programs, press the C key and enter other program numbers. 12 is entered, an account number will appear in the copy quantity display. If no account number has been registered, "12E" will appear in the copy quantity display. Use the copy ratio display (%) key % to select the account number to be changed. Use the % key to advance through the account numbers. Enter a new account number using the 10-key pad. If a number that is already registered or "000" is entered, the number will blink in the copy quantity display. [. . . ] 1 Set the originals in the document feeder tray face up with the stapling position in the upper left corner. Make sure that there is no paper in any sort bin before selecting the STAPLE SORT ( ) mode. When copying and sorting are completed, each set of copies will be automatically stapled. Sets of copies containing copies of different width will not be stapled. [. . . ]