User manual SHARP SF-820

[. . . ] The socket-outlet shall be installed near the equipment and shall be easily accessible. 1 2 3 4 5 6 7 8 Document cover Document glass Operation panel Exit tray Single bypass guides Single bypass Drum unit Power switch 9 10 11 12 13 14 15 16 Paper tray Release lever* Toner cartridge Fusing unit Fusing unit lever SPF exit tray Original guides SPF tray 17 Operation manual 18 Power cord * Do not press this lever during copying *1 When the copy ratio display key or a zoom key is pressed, the copy ratio will appear in the copy quantity display. 1 2 3 4 5 6 7 8 9 10 Exposure indicators Drum replacement required indicator Misfeed indicator Toner required indicator Copy ratio indicators Zoom indicator Copy ratio display key Copy quantity display *1 Power save indicator Exposure mode selector key and indicators 11 12 13 14 15 16 17 18 19 20 Light key Dark key Tray select key and indicators Copy ratio selector key Zoom keys 10-key pad Clear key Print key and ready indicator SPF indicator SPF misfeed indicator This copier has been designed to provide intuitive operating ease while requiring a minimum amount of space. its main features are: · Space conservation with a fixed platen and a frontloading tray; · Power savings with preheat and auto power shut-off modes; · Optional 250 sheet paper feed unit available (SF-CM14) In addition, the SF-820 has a 20 sheet original feeder which can increase productivity when copying multi page documents. [. . . ] Use the tray select (M) key to select either the paper tray or the bypass tray for the feeding of paper. Copy paper in the paper tray is always selected unless paper is fed into the single bypass. Set the number of copies and press the print (z) key to make a copy. The bypass automatically feeds one sheet of standard copy paper and also feeds special papers such as transparency film and labels one sheet at a time. Copy paper measuring from A6 to B4 and in the weight range of 52 to 130 g/m2 can be used in this tray. (A4 is the maximum size for paper weighting from 104 to 130 g/m2. Set the paper guide to the copy paper width. ⷠPaper must be fed narrow side into the feed slot. Insert a single sheet of paper into the feed slot. Two-sided copies can be made on these copiers using the bypass tray or manual bypass. Place the first original on the document glass and make a copy. This indicates the number of originals that must be returned to the SPF tray after a misfeed. Return the required number of originals. Then this number will disappear when copying is resumed or the clear (>) key is pressed. When the SPF misfeeds an original sheet, the copier will stop and the SPF misfeed ( ) indicator will blink, while the misfeed (t) indicator will remain off. Misfeed in the SPF An original misfeed may occur at one of three locations: (A) in the SPF tray, (B) in the exit area, or (C) under the roller. (A) Gently pull the misfed original(s) to the right and out from the SPF tray. ⷠOpen and close the document cover to clear the indicator. Location/Position (B) (B) Pull any misfed originals out from the original exit area. ⷠOpen and close the document cover to clear the indicator. Location/Position (C) (C) Open the document cover and remove any misfed originals. NOTE: A number may appear in the copy quantity display after a minus sign ("­"), indicating the number of originals that must be returned to the SPF tray. [. . . ] Specifications are subject to change for improvement without notice. Gently lift and pull out a paper tray from the paper feed unit. Fan the copy paper and insert it into the tray. ⷠIf you change to a different size of copy paper, the tray must be adjusted. [. . . ]