User manual SHARP SJ-MB300S

[. . . ] Do not use mechanical devices or other artificial means to accelerate the defrosting process. If this appliance is to replace an old refrigerator with a lock; break or remove the lock as a safety measure before storing it, to protect children while playing might lock themselves inside. Old refrigerators and freezers contain insulation gases and refrigerant, which must be disposed of properly. Entrust the disposal of a scrap unit categorically to competence of your local waste disposal service and contact your local authority or your dealer if you have any questions. [. . . ] If the socket does not match the refrigerator plug, replace the plug with a suitable one (at least 16 A) · Insert the plug into a socket with an efficient ground connection. If the socket has no ground contact or the plug does not match, we suggest you to call an authorised electrician for assistance. The plug should be accessible after the appliance is positioned. Manufacturer is not responsible for failure to complete the ground connection as described in this booklet. Do not use in open air and shall not be exposed to the rain. The refrigerator should be at least 50 cm from radiators, gas or coal stoves and 5 cm far from electrical stoves. Fit the plastic wall spacers to the condenser at the back of the refrigerator in order to prevent leaning to the wall for good performance. Do not place heavy and lots of things on the appliance. If the appliance is installed next to another refrigerator or freezer, observe a minimum distance of 2 cm to prevent condensation. The appliance must be stand firmly and level on the floor Use the two front levelling-feet to compensate for an even floor. The outside of the appliance and the accessories inside should be cleaned with a solution of water and liquid soap; the inside of the appliance with sodium bicarbonate dissolved in lukewarm water. Then turn the thermostat dial to position "5" (max position) and switch the super switch ON until the RED lamp is off (Note that; for best internal temperature the indicator in the thermostat should be positioned between 2 and 4. ) · When you first switch on the appliance, for starting a suitable cooling, the appliance should work with in 24 hours continuously until it cools down to sufficient temperature. In this time do not open the door so often and place a lot of food inside the appliance. If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting or re-plugged the unit in order not to damage the compressor. Fill the ice tray with water and place in freezer compartment. After the water completely turned into ice, you can twist the tray as shown below to get the ice cube. Frost tends to concentrate in the coldest parts of the evaporator and in time will require more frequent defrosting. Never place warm food in the refrigerator. Warm food should be allowed to cool at room temperature and should be arranged to ensure adequate air circulation in the refrigerator compartment. Nothing should touch to refrigerator back wall as it will cause frost and the packages can stick here. Do not open the refrigerator door too frequently. [. . . ] Fast freezing shelves are the middle drawers of the freezer compartment (see in page 14) Disconnect unit from the power supply before cleaning. The refrigerator and freezer compartment should be cleaned periodically using a solution of bicarbonate of soda and lukewarm water Clean the accessories separately with soap and water. Do not clean them in the washing machine. After washing, rinse with clean water and dry carefully. [. . . ]