User manual SHARP SYSTEM-CD555H

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: !Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] To stop the auto tuning, press the or button again. To receive an FM stereo transmission: Press the BAND button to display the "STEREO" indicator. "ST" will appear when an FM broadcast is in stereo. FM stereo receiving indicator FM stereo mode indicator !If the FM reception is weak, press the BAND button to extinguish the "STEREO" indicator. The reception changes to monaural, and the sound becomes clearer. After use: Press the ON/STAND-BY button to enter the power stand-by mode. E-25 Listening to the memorized station " Memorizing a station You can store 40 AM and FM stations in memory and recall them at the push of a button. (Preset tuning) SD-AT50 DX-AT50 " To recall a memorized station Press the TUNER PRESET ( tion. or ) button to select the desired sta- ENGLISH 1 2 3 Perform steps 1 - 3 in "Listening to the radio" on page 25. Press the ENTER button to enter the preset tuning saving mode. Within 5 seconds, press the TUNER PRESET ( or ) button to select the preset channel number. Preset channel It's easier with the direct buttons on the remote control. Store the stations in memory, in order, starting with preset channel 1. 4 Within 5 seconds, press the ENTER button to store that station in memory. " To erase all the contents of the preset memory 1 2 Hold the CLEAR button down for 3 seconds or more. While "CLEAR" is displayed, press the ENT button. 5 Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorized will be erased. [Back] Note: The backup function protects the memorized stations for a few hours should there be a power failure or the AC power cord disconnection. E-26 - Listening to the memorized station - For 1st to 10th stations --- Select the preset number between "1" and "10/0". For 11th to 40th stations --- Press ">10" and select the preset number. Depending on the disc, playback may resume from slightly before the stopped position. " Headphones !Before plugging in or unplugging the headphones, reduce the volume. Be sure your headphones have a 1/8" (3. 5 mm) diameter plug and are between 16 ohms and 50 ohms impedance. Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME buttons. You cannot use the surround feature with headphones. E-28 - Playing a disc - SD-AT50 DX-AT50 Basic operation [Front] [Back] ENGLISH " Fast forward/Fast reverse (search) You can search the desired point as you play the disc. 1 While a disc is playing, press the Example: When the button is pressed or button. !The scanning speed will change as follows at each press of the button. Advanced Disc Features 2 (about 2 times) 8 (about 8 times) 60 (about 60 times) !The disc is forwarded by the 30 (about 30 times) button and reversed by the button. - Basic operation - 2 " To locate the beginning of a chapter (track) (skip) You can skip the current chapter (track) to the next. !! Press the DVD/CD button to return to the normal playback. Notes: On some discs, the search function is disabled. On a DVD, search does not operate between titles. While searching on a DVD the sound is not heard and the subtitles will not appear. [. . . ] Lens cleaners are commercially available. Contact your local DVD software dealer for options. Optional accessories Use only the specified optional accessories to operate this product properly. For speaker installation, read instructions supplied with stands or brackets. FLOOR SPEAKER STAND Model: AD-AT10ST TABLE SPEAKER STAND Model: AD-AT10LS References SPEAKER WALL BRACKET Model: AD-AT10SA OPTICAL DIGITAL CABLE Model: AD-M1DC The appearance of optional accessories may differ from the illustrations above. E-51 SD-AT50 DX-AT50 ENGLISH " AV Control Unit Width: 8-1/2" (215 mm) Height: 2-5/16" (58 mm) Depth: 10-5/16" (261 mm) Weight 2. 9 lbs. [. . . ]