User manual SHARP SYSTEM-U1H

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ] but- 19 CD Playback To cancel random play: Press the / button. "R" will go out. SYSTEM-U1H CD-ES66 Advanced CD Playback (continued) !Programmed play You can choose up to 32 selections for playback in the order you like. 1 While in the stop mode, press the MEMORY/SET (MEMORY) button to enter the programming save mode. To clear the programmed selections: Press the CLEAR/DIMMER button on the remote control while the "MEMORY" indicator is flashing. Each time the button is pressed, one track will be cleared, beginning with the last track programmed. To cancel the programmed play mode: While in the stop mode and the "MEMORY" indicator is lit, press the CLEAR/DIMMER button on the remote control. The "MEMORY" indicator will disappear and all the programmed contents will be cleared. Adding tracks to the program: If a program has been previously stored, the "MEMORY" indicator will be displayed. The new tracks will be stored after the last track of the original program. To check which tracks are programmed: While the unit is stopped in the programmed play mode, press the or button. Notes: " When a disc with programmed tracks is ejected, the program is automatically canceled. " Even if you press the ON/STAND-BY button to enter the stand-by mode or change the function from CD to another, the programmed selections will not be cleared. Press the MEMORY/SET (MEMORY) button to enter the preset tuning saving mode. !To scan the preset stations The stations saved in memory can be scanned automatically. (Preset memory scan) 1 2 Press the PRESET ( or ) button for more than 0. 5 seconds. The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each. Press the PRESET ( or ) button again when the desired station is located. 3 Radio Within 30 seconds, press the PRESET ( or ) button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1. Within 30 seconds, press the MEMORY/SET (MEMORY) button to store that station in memory. 4 If the "MEMORY" and preset number indicators go out before the station is memorized, repeat the operation from step 2. 5 Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorized will be erased. !To erase entire preset memory 1 2 Press the ON/STAND-BY button to enter the stand-by mode. While pressing down the button and the X-BASS/DEMO button, press the CLOCK/TIMER button until "TUNER CL" appears. Note: The backup function protects the memorized stations for a few hours should there be a power failure or the AC power cord disconnection. 22 Listening to a cassette tape (TAPE 1 or TAPE 2) Before playback: " For playback, use normal or low-noise tapes for the best sound. (Metal or CrO tapes are not recommended. ) " Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. [. . . ] There may be some deviations from these values in individual units. SYSTEM-U1H CD-ES66 !Tuner Frequency range FM: 87. 5 - 108. 0 MHz AM: 530 - 1, 720 kHz !General Power source Power consumption Dimensions AC 120 V, 60 Hz 108 W Width: 10-1/4" (260 mm) Height: 13" (330 mm) Depth: 12-7/8" (326 mm) 17. 2 lbs. Cassette deck Frequency response Signal/noise ratio Wow and flutter 50 - 14, 000 Hz (normal tape) 55 dB (TAPE-1 playback) 50 dB (TAPE-2 recording/playback) 0. 3 % (WRMS) Weight ! [. . . ]