User manual SHARP UP-X300C DATASHEET

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at their own expense. In Canada This class A digital apparatus complies with Canadian ICES-003. Please record below the model number and serial number for easy reference in case of loss or theft. These numbers are located on the bottom of the unit. [. . . ] When you use the optional cradle charger (UP-B01CH) for charging battery, follow the procedure shown below. Plug the AC power cord into an AC outlet. Make sure that the terminal is fully inserted into the cradle charger. the charge indicator on the terminal will illuminate orange when charging begins. Note: Please make sure that the power indicator turns green when the mobile terminal is placed in the cradle. If the terminal is not placed correctly, the power indicator will not light. When charging has been completed, the charge indicator will turn off. Upon completion, lift the mobile terminal from the cradle charger. Unplug the AC power cord from the AC outlet and unplug the AC The AC power cord plug may differ in some countries. â· Do not use the AC adapter for other equipment. Do not use voltages beyond the indicated power supply voltage range. Triangle (L), plus (+), and minus (-) marks on the battery are aligned correctly with those printed inside the battery compartment. Also make sure each ribbon tab is placed under the battery as shown in the diagram to the right. Caution: Be sure to replace the battery compartment lid after inserting the battery. If the cover is not on securely, the battery may not keep a proper connection and you may lose the data which is stored in the terminal. About the back-up battery The UP-X300C has a specified built-in rechargeable back-up battery which prevents the memory contents from being erased when you replace the batteries. â· The rechargeable back-up battery will be charged to its full capacity in approximately 24 hours using a fully charged "EA-BL08" operating battery. â· The rechargeable back-up battery (when fully charged) keeps data stored in the UP-X300C for approximately 10 minutes when the operating battery is not inserted. The malfunctions shown in the left-hand column below, labeled "Condition, " does not necessarily indicate functional faults of the terminal. The condition listed is only meant to be a reference for the items shown in the "Possible Cause and Remedies" column at the right before calling for service. The mobile terminal does not turn on by pressing the power on/off key. The following SHARP options are available for your UP-X300C mobile terminal: For further details about options listed below, please contact your SHARP dealer. [. . . ] Any changes or modifications to Symbol Technologies equipment not expressly approved by Symbol Technologies could void the user authority to operate the equipment. Radio Frequency Interference Requirements This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the Federal Communications Commissions (FCC) Rules and Regulation. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ]