User manual SHARP UPV5500

[. . . ] DriveClone Pro User's Guide Copyright Notice No part of this publication may be copied, transmitted, stored in a retrieval system or translated into any language in any form or by any means without the expressed written permission of FarStone Technology, Inc. FarStone grants you the right to use one copy of the enclosed software program ("SOFTWARE") on a single computer. If the SOFTWARE is installed on a network, or more than one user can run the SOFTWARE at the same time, you must purchase an additional license for each additional user or computer. Trademark FarStone® is a trademark of FarStone Technology, Inc. Microsoft, Windows® and MS-DOS® are registered trademarks of Microsoft Corporation. [. . . ] Some optional settings will display if you click Advanced, including compression mode, password protection, image split, integrity check, backup priority, backup description and network connection speed. Review the information and settings that have been specified. Click Next to launch the backup process. Or click Previous to modify setting(s). 23 Tip If the system is busy, and DriveClone can not start the backup process successfully, DriveClone will try to back up again automatically. 10. Click Finish to return to main console. Creating an Incremental Backup 1. Select Back Up and click Back Up Computer(s). Select Incremental Backup and click Next. Select an existing job from the Job List. 5. Review your information and settings, and click Next to launch the incremental backup. Click Finish to return to the main console. 4. 3 Restore Console 4. 3. 1 Return to a System Snapshot This feature can be available only if you install System Snapshot and take system snapshots for you system snapshot. Click Restore and then click Return to a System Snapshot on the main interface. Select the date you want to restore to from the calendar on the left pane and select the System Snapshot of that day you would like to restore to on the right pane and click Next. You can also click Preview System Snapshot to view its content prior to restoration. Then if you want to close the Preview Drives, click Close Preview Drives in the Tools tab or in the menu to close the Preview Drives. Choose to restore the Entire Hard Drive or C : Drive Only and then click Next to begin the restoration. 3. Tip If the user chooses to restore the C Drive only, DriveClone only restores the files of the active partition. All of the System Snapshots created before the restoration point can only be used to restore the C: drive. 24 4. And then click OK to proceed to the next step. Your computer will restart automatically to start the restoration process. 4. 3. 2 Restore Files To restore file(s), please do the following: 1. Select Restore and then click Restore Files. Select a backup image file from the drop down list. You can also click here to select it on a network share. Select Files from the most recent backup or Files from a previous backup and click Next. If you select Files from a previous backup, please select the backup point you want to restore from the list. [. . . ] Why does it take more time to install System Snapshot on my computer than on other systems? 43 A: If there are too many dispersed/fragmented files in your system partitions, DriveClone Pro will defragment them to free up continuous space for the application's kernel file Secure Area. Moreover, when you install System Snapshots on a FAT32 partition, DriveClone Pro will divide the Secure Area, which takes much longer time than an installation on NTFS partitions. How can a PC be restored following a data disaster?A: There are three ways to boot the PC: 1. [. . . ]