Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SHARP UP-X200. We hope that this SHARP UP-X200 user guide will be useful to you.
Lastmanuals help download the user guide SHARP UP-X200.
Detailed instructions for use are in the User's Guide.
[. . . ] Please read this manual carefully before operating your Mobile Terminal. Please keep this manual for future reference. Keep this terminal away from extreme heat. Do not leave it on the dashboard of a car or near a heater. [. . . ] ⷠDo not use the AC adapter for other equipment. Do not use voltages beyond the indicated power supply voltage range. ⷠWhen the cradle charger is not in use, disconnect the AC power cord and the AC adapter from the wall outlet for safety purposes. ⷠDo not connect or disconnect the AC adapter with wet hands. ⷠThe AC plug must comply with the AC outlet configuration. When using the optional battery charger (UP-P01CH) for charging the battery, follow the procedure shown below. You must remove the batteries from the mobile terminal for charging. to remove and install the batteries , please refer to the next page. Note: Only use the SHARP model EA-BL08 rechargeable battery. Connect the AC power cord to the battery charger and plug the other end into an AC outlet. Make sure that the triangle (L), plus (+), and minus (-) marks on the battery are aligned correctly with those indicated on the battery charger. the charge indicator on the battery charger will illuminate red when charging begins. The charging time is approximately 3 hours, and may vary depending on the ambient temperature and operating conditions. When the charging has been completed, the charge indicator will turn off. Unplug the AC power cord from the AC outlet and from the battery charger. The AC power cord plug may differ in some countries. ⷠDo not use voltages beyond the indicated power supply voltage range. ⷠWhen not in use, disconnect the AC power cord from the wall outlet for safety. Caution: Be sure to follow the procedures listed below when you replace the batteries. Otherwise data and settings may be lost. ⷠTurn off the mobile terminal before replacing the batteries. ⷠWhen you replace the batteries, install spare batteries within 10 minutes under the condition the back-up battery is fully charged. [. . . ] The WLAN card has been tested and found to comply with the Federal Communications Commission(FCC) guidelines on radio frequency energy (RF) exposures. ⷠThis transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. european Economic Area (EEA) RLAN's (2. 4GHz) for use through the EEA have the following restrictions: · France outside, the equipment is to be restricted to power of less than 10mW, about 2. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP UP-X200
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP UP-X200 will begin.
