User manual SHARP UX-B800

[. . . ] Open the cover () and remove the tape (). 2 2. (Do not install the print cartridge yet. ). Quick Setup Guide Inkjet Fax UX-B800 1 2 Connect the handset 3 Attach the trays Attach the document exit tray and flip out the extension Attach the paper tray Attach the received document tray Pull the received document tray extension all the way out 4 Load paper Fan the paper, and tap the edges against a flat surface to even the stack. The stack should not be higher than this line 5 1. [. . . ] Close the holder (), making sure it clicks into place. 2 1 5. Close the cover, pressing firmly on both front corners. 6. . The machine will print an alignment page. 7. In the alignment page, locate the line that is closest to a completely straight line. Example: (To clear a mistake, press . ) In this example, "15" is closest to a straight line 8. Note: To enter your name and fax number and set the date and time so that they appear at the top of each fax page you send, see pages 13 - 14 of the manual. Display: CHANGE CARTRIDGE 1=NEW, 2=OLD 7 Internet Setup for Fax/Scan to E-mail WAN port Cable/DSL modem Connect one end of an Ethernet cable (not included)* to the LAN port on the machine, and the other end to a LAN port on your router, switch, or hub. The machine requires an IP address to communicate. Most networks assign an IP address automatically when a device is connected. If your network requires that a permanent IP address be assigned to the machine, see page 25 of the manual. Open the browser on a computer connected to the same network as the machine, and type in the machine's IP address in the Address bar of the browser. Select "E-mail Setup" in the menu frame and configure the settings. For detailed information on each setting, click "Help" in the menu frame. If you don't know the information that must be entered in each setting, ask your Internet service provider. Example: LAN cable LAN ports (Hub/Switch) LAN cable LAN cable Router LAN cable To use Fax/Scan-to-E-mail, you must configure the "Sender *Please purchase a straightAddress", and "SMTP Server" settings (see pages 17 -19 of through (regular) Ethernet cable that supports 10Base-T. [. . . ] Press , then INFORMATION]. to show [NETWORK 3. The address will appear on the bottom line of the display. [. . . ]