User manual SHARP VC-C73SA

[. . . ] There may be some deviations from these values in individual units. Operation Manual Mounting Bracket Applicable models (as of July 2008) LCD MONITOR LB-1085 VC-C73SA Unit: mm (inch) (The figure shows the approximate values. ) Thank you for purchasing a SHARP product. Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section "To ensure safe and correct use". [. . . ] In particular, be sure to read the section "To ensure safe and correct use". After reading the manual, keep it in a convenient location where it can be accessed at any time. · TIPS 1835 (72 1/4) - Please understand that Sharp Corporation bears no responsibility for errors made during use by the customer or a third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law. - This product and its accessories may be upgraded without advance notice. To ensure safe and correct use 116 (4 9/16) 97 (3 13/16) This operation manual and the product use various displays and labels to ensure safe use. Ignoring these displays and labels and incorrectly using the product could have results as classified below. Please read the following warning symbol information before reading the rest of this section, and be sure to strictly observe all instructions. Warning: Not following these instructions could result in death or serious injury. · The installation must be performed by qualified service personnel. Improper installation work may cause the monitor to fall or topple over, resulting in injury. · Only use the accessories with specified models. Do not modify the LCD Monitor or the accessories. For details, contact your product dealer. Attach the mounting brackets by inserting the bolts through the 2 holes in the center. 2) Confirm that the mounting brackets are securely hooked and then attach the 2 supplied countersunk bolts. Tighten the countersunk bolts while gradually loosening the chains of the hoisting device. Countersunk bolt 3) Installation procedure Caution · The LCD Monitor is large and heavy. It must be moved with a hoisting device (chain block, etc. ). · Installation requires at least four people. 3) Secure the mounting brackets with 4 supplied M16 bolts inserted into the remaining 2 holes on each side. M16 plain washer M16 spring washer Countersunk bolt plain washer 1 2 Move the LCD Monitor in front of the H-shaped steel frame to which it will be attached. Insert the hooks of the hoisting device into the eye bolts of the LCD Monitor and slightly lift the monitor. · Lift up the monitor so that the hoisting chains become taut. 3 Remove the stand mounting bolts on the rear and detach the LCD Monitor from the stand. [. . . ] Insert the hooks of the hoisting device into the eye bolts of the LCD Monitor and slightly lift the monitor. · Lift up the monitor so that the hoisting chains become taut. 3 Remove the stand mounting bolts on the rear and detach the LCD Monitor from the stand. · Loosen the 8 bolts gradually and evenly. [. . . ]