User manual SHARP VC-M27GM

[. . . ] Please refer to the relevant laws in your Country. q No part of this publication may be reproduced, stored or transmitted in any form without prior permission from SHARP Electronics (UK) Ltd. is a registered trademark of Gemstar Development Corporation. The system is manufactured under licence from Gemstar Development Corporation. THIS MANUAL COVERS A RANGE OF MODELS. ALL OF THE FEATURES MENTIONED MAY NOT NECESSARILY APPLY TO YOUR VCR. E Estimado Cliente SHARP Gracias por adquirir este VCR de SHARP. Si lo cuida correctamente, disfrutar durante aos de sus caractersticas. [. . . ] appears on the VCR display, press TIMER ON/OFF before starting. Check that the clock is displaying the correct time. SETTING A RECORDING For example: Recording a programme on channel 3 from 21:05 to 22:30 on July 9th. 1. Press SET to confirm. MENU SCREEN 4. The position which is initially highlighted is the next available timer record entry. The display will automatically show today's date. Either: If this is the date you wish to make the recording on, press SET to confirm this. Or: enter the recording date using the [ / ] or the NUMBER BUTTONS. Enter two digits for the day, then two for the month. For example for July 9th, press 0 9 (9th), then 0 7 (July). T I ME R MOD E SE T UP SET : SE L ECT : ENT ER ME NU : E X I T 1/2 DA T E 21 / 06 9 / 07 --/---/-P R S T AR T S T OP 02 12 : 00 13 : 00 --:--:---:--:---:--:-SP * ------- 5. If you want to make additional recordings at the same time each day or week, use [ / ] or select D (daily) or W (weekly). Then press SET to confirm. 1/2 DA T E P R S T AR T S T OP 21 / 06 02 12 : 00 13 : 00 9 / 0 7D - -:--:---/-- --:--:---/-- --:--:-SP * ------- 7. Enter the channel using the [ / ] or the NUMBER BUTTONS. You can check the settings and change or cancel them. SET : SE L ECT : ENT ER ME NU : E X I T CHANGING A RECORDING 1. Follow steps 1 to 4 of CHECKING A RECORDING. 1/2 DA T E 21 / 06 --/---/---/-P R S T AR T S T OP 02 12 : 00 13 : 00 --:--:---:--:---:--:-SP * ------- 2. If you wish to change a delayed recording, press [ / ] to highlight the recording, then press SET. 3. Press [ / ] to highlight the setting to be changed and correct it by using the[ / or the NUMBER BUTTONS. When all corrections are complete press SET, CANCELLING A RECORDING 1. Follow steps 1 to 4 of CHECKING A RECORDING. 2. If you wish to cancel a delayed recording, press [ / ] to highlight the recording to be cancelled, then press CLEAR. 1/2 DA T E P R S T AR T S T OP 2 1 / 0 6 0 2 1 2 : 0 0 1 3 : 0 0 SP * --/-- --:--:-- ----/-- --:--:-- ----/-- --:--:-- --- 3. Press MENU. NOTE: If there are some programmes to be recorded, do not forget to press TIMER ON/OFF button to return the VCR to TIMER STAND-BY mode. GB-15 741 eng. book Page 16 Tuesday, April 27, 1999 11:35 AM ADVANCED OPERATION AUDIO AND YOUR VCR HI-FI STEREO SOUND (HiFi VCR'S ONLY) Stereo sound is possible from this VCR if you have a stereo TV connected to the VCR with a scart lead, or audio equipment connected with audio phono leads. The VCR is normally set so that stereo sound is possible. The sound output from the VCR is controlled by the AUDIO OUT button on the remote control. If you wish to change the sound output you can use the AUDIO OUT button as follows: Press AUDIO OUT once. [. . . ] DISPLAY OFF, this will remove the display from the screen. REM 1:05 0:00. 00 NOTES: The default time and date will not be displayed if the clock has not been set. If you are recording from this VCR to another, make sure you remove the display from the screen otherwise it will be recorded. GB-33 741 eng. book Page 34 Tuesday, April 27, 1999 11:35 AM MORE INFORMATION ABOUT YOUR VCR SPECIFICATIONS Format: Number of heads: Video signal system:: Hi-Fi audio recording system: Maximum playing time: Tape width: Tape speed: Antenna: Reception channels: RF output signal: Power requirement: Power consumption: Operating temperature: Storage temperature: Video input: Video output: Audio input: Audio output: Hi-Fi audio: VHS PAL standard Four heads PAL/MESECAM colour or monochrome signal: 625 lines Deep layer recording system conforming to stereo Hi-Fi VHS standard. with E-240 video cassette in Long Play (LP) mode 12. 7 mm 23. 39 mm/s Standard Play (SP): 11. 70 mm/s Long Play (LP) 75 unbalanced VHF channel E2 - S41, UHF channel 21-69 UHF channel 21-69 AC 230V, 50 Hz 16 W approx (Low power consumption 2W) 5 C to 40 C -20 C to 55 C 1. 0 Vp-p, 75 1. 0 Vp-p, 75 Line1&2: -3. 8 dBs, 10 k, Line 3: -5. 0 dBs, 47 k Line1&2: -3. 8 dBs, 1 k Audio Out: -5. 0 dBs, 1 k Dynamic range:~ 90 dBs typ. (SP); Frequency response: 20 Hz - 20 kHz; Wow and flutter: < 0. 005% Wrm (JIS A) 360(W) x 289(D) x 93(H) mm 3. 2 kg (approx) 75 HF Connection cable, operation manual, remote control, AA/R6/UM3 battery (x2) Dimensions: Weight: Supplied accessories: Specifications are subject to change without notice as part of our policy of continuous improvement. [. . . ]