User manual SHARP VCA39HM QUICK START GUIDE

[. . . ] ensure that your equipment is connected correctly. If you are in any doubt consult a qualified electrician. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. [. . . ] Use of unauthorized parts can result in fire, electric shock and/or other danger. Safety checks -- Upon completion of service or repair work, request the service technician to perform safety checks to ensure that the product is in proper operating condition. Wall mounting -- When mounting the product on a wall, be sure to install the product according to the method recommended by the manufacturer. Heat sources -- Keep the product away from heat sources such as radiators, heaters, stoves and other heat-generating products (including amplifiers). Batteries -- Incorrect use of batteries may cause the batteries to burst or ignite. A leaky battery may corrode the equipment, dirty your hands or spoil your clothing. In order to avoid these problems, make sure to observe the precautions below: · Install the batteries with due attention to the plus (+) and minus (-) sides of the batteries according to the instructions in the compartment. Do not mix batteries of different types. Replace an exhausted battery with a new one promptly. If you will not use the remote control for a long time, remove the batteries. If leaked battery fluid gets on your skin or clothing, rinse immediately and thoroughly. Do not allow the monitor to receive strong shocks or to strongly vibrate. causing the monitor to fall or topple over may damage it. - Do not use the monitor near heating equipment or in places where there is likelihood of high temperature, as this may lead to generation of excessive heat and outbreak of fire. - Do not use the monitor in places where it may be exposed to direct sunlight. - The AC outlet shall be installed near the equipment and shall be easily accessible. - Do not operate the screen with a hard or pointed object such as a fingernail, pen, or pencil. - Use only the power cord supplied with the monitor. - Do not damage the power cord nor place heavy objects on it, stretch it or over bend it. - Do not use the power cord with a power tap. adding an extension cord may lead to fire as a result of overheating. - Do not remove or insert the power plug with wet hands. [. . . ] Touch pen: 1 Pen tip (for touch pen): 2 Touch pen battery (LR-03 ("AAA" size)): 1 USB cable: 1 Eraser: 1 Tray: 1 Tray mounting fitting (cover / bracket): x 2 Tray mounting screws: M5 x 4 / M4 x 2 Terminal label: 1 Used when installing the interface expansion board PN-ZB01 (optional). Cover Sharp logo: 1 Place this sticker onto the SHARP logo to cover the logo. Follow the disposal instructions for your area. Rotate the battery cap and remove it, and then pull out the cover. [. . . ]