User manual SHARP VCA46HM OPERATION MANUAL

[. . . ] ensure that your equipment is connected correctly. If you are in any doubt consult a qualified electrician. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. [. . . ] Improper adjustment of controls not described in the instructions can cause damage, which often requires extensive adjustment work by a qualified technician. When the product has been dropped or damaged. Any noticeable abnormality in the product indicates that the product needs servicing. Replacement parts -- In case the product needs replacement parts, make sure that the service person uses replacement parts specified by the manufacturer, or those with the same characteristics and performance as the original parts. Use of unauthorized parts can result in fire, electric shock and/or other danger. Safety checks -- Upon completion of service or repair work, request the service technician to perform safety checks to ensure that the product is in proper operating condition. Wall mounting -- When mounting the product on a wall, be sure to install the product according to the method recommended by the manufacturer. Heat sources -- Keep the product away from heat sources such as radiators, heaters, stoves and other heat-generating products (including amplifiers). Batteries -- Incorrect use of batteries may cause the batteries to burst or ignite. A leaky battery may corrode the equipment, dirty your hands or spoil your clothing. In order to avoid these problems, make sure to observe the precautions below: · Install the batteries with due attention to the plus (+) and minus (-) sides of the batteries according to the instructions in the compartment. - Care should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by curious children. - Do not use the monitor where there is a lot of dust, where humidity is high, or where the monitor may come into contact with oil or steam, as this could lead to fire. - Ensure that the monitor does not come into contact with water or other fluids. Ensure that no objects such as paper clips or pins enter the monitor as this could lead to fire or electric shock. - Do not place the monitor on top of unstable objects or in unsafe places. Do not allow the monitor to receive strong shocks or to strongly vibrate. causing the monitor to fall or topple over may damage it. - Do not use the monitor near heating equipment or in places where there is likelihood of high temperature, as this may lead to generation of excessive heat and outbreak of fire. - Do not use the monitor in places where it may be exposed to direct sunlight. - The AC outlet shall be installed near the equipment and shall be easily accessible. - Use only the power cord supplied with the monitor. [. . . ] Adhere to the following when installing the monitor in its portrait orientation. failing to adhere to the following may cause malfunctions. - Install the monitor such that the power LED is located on the bottom side. ) - Be sure to clamp the power cord (supplied) onto the cable clamp attachment using the supplied cable clamp. [. . . ]