User manual SHARP VC-C50SA

[. . . ] The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Operation Manual Support rod Applicable models (as of July 2008) LCD MONITOR LB-1085 VC-C50SA Unit: mm (inch) (The figure shows the approximate values. ) Thank you for purchasing a SHARP product. [. . . ] Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section "To ensure safe and correct use". After reading the manual, keep it in a convenient location where it can be accessed at any time. · TIPS 826 (32 1/2) - Please understand that Sharp Corporation bears no responsibility for errors made during use by the customer or a third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law. - This product and its accessories may be upgraded without advance notice. To ensure safe and correct use 57 (2 1/4) 50 (1 15/16) This operation manual and the product use various displays and labels to ensure safe use. Ignoring these displays and labels and incorrectly using the product could have results as classified below. Please read the following warning symbol information before reading the rest of this section, and be sure to strictly observe all instructions. Warning: Not following these instructions could result in death or serious injury. · The installation must be performed by qualified service personnel. Improper installation work may cause the monitor to fall or topple over, resulting in injury. · Lift up the monitor so that the hoisting chains become taut. 4 Mount the support rods to the stand. · Mount using the supplied M8 bolts. · The support rods can be mounted at two different heights. Spring washer Plain washer 1500 mm* (59 1/16 inch) Precautions on use · The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel. Installation requires special knowledge and qualifications. · Customers should not attempt to install, remove, or transport the LCD Monitor by themselves. · SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling. 1600 mm* (63 inch) *Height to center of the LCD Monitor 3 Remove the stand mounting bolts on the rear and detach the LCD Monitor from the stand. · Loosen the 8 bolts gradually and evenly. [. . . ] · Loosen the 8 bolts gradually and evenly. If it is difficult to loosen the bolts, lift the monitor up slightly with the hoisting device to reduce the load on the bolts. [. . . ]