User manual SHARP VC-D801S

[. . . ] Please refer to the relevant laws in your country. G No part of this publication may be reproduced, stored or transmitted in any form without prior permission from SHARP Electronics (Europe) GmbH. ® and PlusCode ® are registered trademarks of Gemstar Development G Corporation. G system is manufactured under license from Gemstar Development Corporation. THIS MANUAL COVERS A RANGE OF MODELS. ALL OF THE FEATURES MENTIONED MAY NOT NECESSARILY APPLY TO YOUR VCR. SAFETY WARNINGS Observe all warnings for your safety and to ensure trouble free use of your VCR. INFORMATION Additional information complements instructions. (i) VCR REMOTE CONTROL 14. PLUSCODE TIMER ON/OFF MENU OPERATE INPUT SELECT AUDIO OUT CH VOL + 15. TV VOLUME + CH SKIP SEARCH VOL ZERO BACK SET / 17. [. . . ] The VCR is normally set so that stereo sound is possible. The sound output from the VCR is controlled by the AUDIO OUT button on the remote control. If you wish to change the sound output you can use the AUDIO OUT button as follows: · · · · Press AUDIO OUT once. The LEFT audio channel will be sent to BOTH speakers. The RIGHT audio channel will be sent to BOTH speakers. The MONO track will be sent to BOTH speakers. L and R will disappear from the VCR display. Pressing AUDIO OUT a fourth time, normal Hi-Fi stereo sound will be heard. L and R will appear on the VCR display. NICAM Hi-Fi STEREO SOUND Your VCR can receive and record programmes broadcast in NICAM sound (the factory preset condition for NICAM is AUTO). NICAM sound may not be stereo, this depends on the programme being received. Audio is automatically recorded in two different ways: (i) Hi-Fi: Using specialised rotary heads, two audio signals are recorded on to the tape. Press MENU to display the main menu on the screen. MODE MENU SCREEN B L U E MU T E R E P E A T AU T O ON OF F OF F 2. Press [ Press [ / ]menu select buttons to ]to select REPEAT. / Press SET. ]to select ON. SET : SE L ECT : ENT ER : CHANGE ME NU : E X I T 7. Press MENU to return to normal screen. If problems persist contact the SHARP Helpline on tel: 0990-274277 19 ADVANCED OPERATION PLAYBACK OF A VIDEO TAPE PLAYING BACK AN NTSC TAPE NTSC (National Television Standards Committee) is a different TV standard to PAL and is used in some Non-European Countries. Your VCR can playback pre-recorded NTSC tapes onto a PAL system TV, but cannot record an NTSC signal onto a video tape. Note that. . · · · · · You cannot record NTSC signals or dub NTSC tapes onto other VCR's from this VCR. You cannot use Slow speed, Still frame, Double Speed, Frame Advance or Tape Remaining with a pre-recorded NTSC tape. On some televisions, the picture may appear in black and white or there may be no picture. This does not indicate a fault with your VCR. On some televisions, the picture may shrink vertically causing black bands to appear at the top and bottom of your screen. On some televisions, the played-back picture may roll vertically, this does not indicate a fault with your VCR. If problems persist contact the SHARP Helpline on tel: 0990-274277 20 ADVANCED OPERATION DIGITAL DISPLAY TIME OF DAY Shows current time of day, if the clock is set. Press DISPLAY until the time of day appears. For example, 21:20 appears: PR OPERATION MODE Shows status of tape. [. . . ] The guarantee does not cover carriage costs, batteries or video tapes. In the unlikely event of this product requiring repair, please contact the supplier from whom it was purchased. Where this is not possible, please contact the SHARP Helpline on the telephone number given below. This guarantee is offered as an additional benefit to your statutory rights and does not affect these rights in any way. [. . . ]