User manual SHARP VC-ME80GM

[. . . ] Given proper core itwill provide years of entertainment for the whole fumily. Please reod this llIerotion manual cOr-llully before attempting to operate the VCR. copyright · Audio-visual mol~riol may consist of copyrightocl works which must not be recorded wilhoutthc outhority of the owner of the copyright. No part of this p'ulJliootion may be reproduceCl, stored or transmitted in ony form without prior permission from SHARP ELECTRONICS {EUROPEj GmIiH. [. . . ] Hi-Fi: Using specialised rotary heads, two audio signals are recorded on to the tape. These will be stereo, mono or bilingual depending on the sound being received. The diagram below shows how to connect your VCR to audio equipment. When connected in this way stereo sound is possible from the speakers. Your VCR will allow you to edit a tape in three different ways in conjunction with another VCR or Cam Corder. This VCR does not playback or record S-VHS format video tapes. The Local Application Control Bus System or LANe jack can be used for controlling the tape Load the source tape into the playback VCR or camcorder ensuring that the record protection tab has been removed. Using the SHUTTLE DIAL find the next starting point on the tape in the playback VCR and ensure the playback VCR is in pause made. Load the source tape info the playback VCR or camcorder ensuring that the record protection tab has been removed. Load the tape to be recorded into your VCR, ensure the record protection tab is in place and ensure the HiFj Ree Level Control is in ifs central position. This will allow you to control the playback VCR from the recording VCR. Press Play/x2 then using the SHUrrLE DIAL find the next starting point on the tape in Press Ploy/x2 then using the SHUTTLE DIAL find the next starting point on the tape in the recording VCR. Shows current time of day, if the clock is set. ZERO BACK uses the tape counter to determine a specific point on a tape you may wish to return fa. When you wish to return to this position on the video fape, press ZERO BACK. CHECKING THE AMOUNT OF TAPE REMAINING tape into the VCR it can calculate approximately the amount of video tape remaining in hours and minutes. This is useful in determining whether or not there is sufficient tape Left to make a recording. When a video tape is playing j the amount of tape remaining is calculated for you automatically. Press DISPLAY on the remote control as many times as necessary until"R" appears on The tape will wind forward and then return to its original position. T~~:~pie, if 1 hour 23 ininutes is left on You can set your VCR to automatically rewind at the end of playing a video tape and replay the entire tape again. NTSC INational Television Standards Committee) is a different TV standard to PAL and is used in some Non-European Countries. Your VCR can playback pre-recorded NTSC tapes onto a PAL system TV, but cannot record an NTSC signal onto a video tape. [. . . ] Make sure there is no other tape in the VCR. Make sure you are loacling the tope correctly. Remote control is too for away from the moin unit. Make sure VCR is not in timer or menu moqe. [. . . ]