User manual SHARP VCS2000 OPERATION MANUAL - PART 7 - MORE INFO ABOUT YOUR VCR, TROUBLESHOOTING, EXTRAS

[. . . ] FULL. , all the active features will also be shown on screen. 2. These depend on model features Programme number and channel Tape Status NICAM signal Audio output mode Tape speed L1 output status Comp or Y/C Tape remaining Time Date Tape counter I SUPER P . SP COMP 22 : 00 9 / 07 00 ON 1 CH 5 9 N I CAM S T E R EO LR R EM 1 : 0 5 0 : 00 . COUNTER, this display will show the tape counter and amount of tape remaining. 3. 4. DISPLAY OFF, this will remove the display from the screen. REM 1:05 0:00. 00 NOTES: · · · The default time and date will not be displayed if the clock has not been set. [. . . ] · Make sure the power cord is plugged in. · Make sure the wall socket has power (plug another appliance in). · Press the TIMER ON/OFF button to disengage timer. PLAYBACK · · · · · Check CHILD LOCK is not engaged. Safety device operating: unplug VCR for 2 hours. Make sure the TV is set to the video channel. Adjust the tracking using CHANNEL / buttons. · The video heads may have been contaminated refer to a SHARP Service Facility. RECORDING Tape is automatically ejected when pressing REC ( ) or TIMER ON/OFF buttons. Playback recording does not playback in stereo. VIDEOPLUS does not record desired programme. Tape can not be loaded. · The record-protection tab has been removed. TAPE TRANSPORT/ MECHANISM · Ensure the VCR is connected to a stereo TV and SCART lead. · Programme may not carry stereo. · Broadcast does not carry VPS/PDC signal which alters recording time. · Check VPS/PDC mode is switched to ON. · Ensure date and time are correctly set on the VCR. · Make sure there is no other tape in the VCR. · Make sure you are loading the tape correctly. Rewind is not possible. · Make sure the tape is not at the start. If problems persist contact the SHARP Helpline on tel: 08705-274277 (office hours) or www. sharp. co. uk/support 50 TROUBLESHOOTING TROUBLESHOOTING AREA REMOTE CONTROL PROBLEM The VCR can not be operated by remote control POSSIBLE CAUSE/CURE · Remote control is too far away from the main unit. · Point the remote control at the VCR. · Batteries are flat - replace both. · Batteries have not been inserted correctly. · VCR is positioned in strong light. · Adjust the position or angle of the satellite receiver. · Re-install all channels ensuring that the satellite receiver is not in any special channel setting mode and that the desired channel is below channel 199 on your satellite receiver. [. . . ] Do not allow water to come into contact with the power supply cord or plug. A damaged power supply cord or loose plug may cause electric shock. Contact your SHARP dealer or a qualified electrician. Do not use the VCR. If problems persist contact the SHARP Helpline on tel: 08705-274277 (office hours) or www. sharp. co. uk/support 54 CALLING FOR SERVICE G If you are unable to resolve a problem using the TROUBLESHOOTING guide, do not remove the cabinet or attempt to service this VCR yourself. [. . . ]