User manual SHARP VR-PK50E

[. . . ] 5 Exitting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 VIEWCAM operation while SV Photo Capture is running . . . . . . . . . . . . . . . . . . . 5 Copyright G Microsoft and Windows are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. G Other names of corporations and products are trademarks or registered trademarks of the respective corporations. [. . . ] Use this to play in the forward direction. Use this to pause playback and display a still image. Use these during still image playback for frame-by-frame playback. Use these to fast-forward and rewind the tape. During playback, use them for forward and reverse search. Use these to zoom in and out. COM Port Settings G This software automatically searches for and selects the COM port assigned for serial connection and there is no need to specify the port. icon, change G If the connection cannot be set automatically, click the the assigned serial port and transfer speed in the connection settings dialog box and then try again. For details on the serial port and transfer speed settings, refer to the operation manual of your computer. Note G If your VIEWCAM is not equipped for the operations described above, these operations cannot be performed with SV Photo Capture. G SV Photo Capture cannot be launched while SV Card Link is running. 3 CONTENTS PREVIOUS PAGE NEXT PAGE Capturing images 7 4 Use the mode select buttons to choose the mode. to capture images being displayed on the LCD · Click screen of the VIEWCAM. · Click to capture images recorded on a tape as the tape is playing. Use the edge smoothing AUTO or OFF button to select whether or not to correct the image to be captured. · When edge smoothing AUTO is selected, images are automatically corrected when they are captured from the VIEWCAM. · When edge smoothing OFF is selected, images are not corrected when they are captured from the VIEWCAM. Note On VIEWCAMS which automatically perform edge smoothing on images, the images are captured with the edge smoothened without having to set this button. Click when the image you want to capture is displayed. · The image stops moving (a still image is displayed) and transfer from the VIEWCAM begins. · The save folder selection dialog box shown below is displayed when transfer is completed. 5 6 Start to view, record or playback the tape on the VIEWCAM to display images on its LCD screen. · When capturing images being displayed on the LCD screen, the zoom buttons (Camera mode) can be used to enlarge or reduce the image you want to capture. · When capturing images being played, use the control buttons (VCR mode) to display the image you want to capture. · When the image capture has been completed, the VIEWCAM returns to the status prior to the image capture. [. . . ] Repeat steps 4 to 7 to capture other images. 7 Troubleshooting If there are communications errors or communications are unstable. . . G Are the VIEWCAM and computer connected properly?Check that the cable is securely connected and that the power is on. G When using SV Card Link, is a media card inserted?Communications are not possible if the card insertion slot is open. [. . . ]