User manual SHARP XGMB70X INTRODUCTION

[. . . ] Before using the projector, please read this operation manual carefully. Introduction Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of inspection, modification, or recall that SHARP may be required to give under the 1972 Consumer Product Safety Act, PLEASE READ CAREFULLY THE IMPORTANT "LIMITED WARRANTY" CLAUSE. ONLY WARNING: High brightness light source. [. . . ] 44 Selecting the Picture mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Adjusting the Image . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Emphasizing the Contrast . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 Adjusting the Color Temperature . . . . . . . . . . . . . . . . . . . . . . . 45 sRGB Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46 Switching the High Brightness/High Contrast . . . . . . . Retain Instructions The safety and operating instructions should be retained for future reference. 3. Heed Warnings All warnings on the product and in the operating instructions should be adhered to. 14. Lightning For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the cable system. This will prevent damage to the product due to lightning and power-line surges. 4. Follow Instructions All operating and use instructions should be followed. 5. Cleaning Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Overloading Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. 6. Attachments Do not use attachments not recommended by the product manufacturer as they may cause hazards. 16. Object and Liquid Entry Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. 7. Water and Moisture Do not use this product near water­for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like. 17. Servicing Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 8. Accessories Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. [. . . ] The internal temperature is abnormally high. (See page 64. ) When Attaching the "QUICK GUIDE" Label Attaching the "QUICK GUIDE" Label (supplied) on the projector will help you check the setup procedure. Ensure to attach the "QUICK GUIDE" Label on the top cabinet of the projector as shown in the drawing on the right. Do not attach the "QUICK GUIDE" label anywhere else to avoid blocking an air intake or exhaust vent. "QUICK GUIDE" Label -12 XG-MB70X_E_P06_17. p65 12 2004. 8. 6, 11:57 AM Introduction Numbers in refer to the main pages in this operation manual where the topic is explained. Projector (Rear View) Terminals Refer to "INPUT/OUTPUT Terminals and Connectable Main Equipment" on page 21. 28 26 26 28 26 23·25 23 23·25 23·25 27 27 INPUT 3 terminal Terminal for connecting video equipment. AUDIO OUTPUT terminal Audio output terminal of equipment connected to the AUDIO INPUT terminal. INPUT 4 terminal Terminal for connecting video equipment with an S-video terminal. OUTPUT (INPUT 1, 2) terminal · Shared computer RGB and component signals output terminal for INPUT 1 and 2. [. . . ]