User manual SHARP XL-1200

[. . . ] This unit contains dangerous voltages, always remove mains plug from the socket before any service operation and when not in use for a long period. Q Warning: To prevent fire or shock hazard, do not expose this appliance to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the apparatus. Q CAUTION Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] change the lighting or the direction of the unit. Z Keep the remote control away from moisture, heat, shock, and vibrations. , , To turn the power on Press the ON/STAND-BY button to turn the power on. When the power is turned on, you can open or close the CD compartment cover by pressing the (OPEN/CLOSE) button. Caution: z Do not stop or move the CD compartment cover manually. Z Be careful not to jam your fingers in the CD compartment cover. Main unit operation: 1 Press the BASS/TREBLE button until "BASS" appears on the display. Main unit operation: 1 Press the BASS/TREBLE button until "TRE" appears on the display. Within 1 minute, press the PRESET ( or ) button to adjust the hour and then press the MEMORY button. This may be operated only with the remote control. Within 1 minute, press the PRESET ( or ) button to adjust the minutes and then press the MEMORY button. After use: Press the ON/STAND-BY button to enter the power stand-by mode. Caution: z Do not stop or move the CD compartment cover manually. Z Be careful not to jam your fingers in the CD compartment cover. Z If the power fails whilst the compartment is open, wait until the power is restored. Z If a disc is damaged, dirty, or loaded upside down, "NO DISC" or "READ ERR" will appear on the display. Z Keep foreign objects out of the CD compartment. Z Subjecting the unit to shock or vibration may cause mistracking. Z When the unit is not being used, be sure to close the CD compartment. If it is left open, the lens may be covered with dust and the unit may not operate properly. Z If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. , , To locate the beginning of a track To move to the beginning of the next track: Press the button for less than 0. [. . . ] Within 5 seconds, press the CLEAR button on the remote control. Note: The backup function protects the memorised stations for a few hours should there be a power failure or the AC power lead disconnection. This may be operated only with the remote control. Timer playback: The unit turns on and plays the desired source (CD, tuner) at the preset time. [. . . ]