User manual SHARP XL-3000C

[. . . ] STAR® Partner, SHARP has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. Many Electrical /Electronic Products use energy both when they are on and when they are off. Americans spend more than $3 billion a year on energy consumed by home electronic products when they are not in use. The new ENERGY STAR® labeled models will reduce that energy "leakage" by up to 75 percent. [. . . ] Z The hour will not advance even if minutes advance from "59" to "00". Within 1 minute, press the PRESET ( or ) button to select 12-hour or 24-hour display and then press the MEMORY button. To confirm the time display when the power is on: Press the CLOCK button. the time display will appear for about 5 seconds. Note: The time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. [Perform to step 3 under "If trouble occurs" on page 26 for details. (0:00 - 23:59) Note that this can only be set when the unit is first installed or it has been reset. (Refer to step 3 under "If trouble occurs" on page 26. Press the POWER button to turn the power on. press the FUNCTION button until "CD STOP" or "NO DISC" appears on the display. When operating with the remote control, press the CD button. Be sure to place 8 cm (3") disc in the middle of a disc holder. Total number of tracks Total playing time When the last track on the disc has finished playing, the CD player will stop automatically. CD Eject Button Notes: z After removing the CD, make sure to press the (OPEN/CLOSE) button and close the CD compartment. Z When the unit enters the stand-by mode, the opened CD compartment cover will be closed automatically. After use: Press the POWER button to enter the power stand-by mode. Caution: z Do not open or close the CD compartment cover manually. Z Be careful not to jam your fingers in the CD compartment cover. Z If the power fails whilst the compartment is open, wait until the power is restored. Z If a disc is damaged, dirty, or loaded upside down, "NO DISC" or "READ ERR" will appear on the display. Z Keep foreign objects out of the CD compartment. Z Subjecting the unit to shock or vibration may cause mistracking. [. . . ] Whilst pressing down the MEMORY/SET button and the button, plug the AC power lead into the AC INPUT socket on the unit. Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth. Caution: z Do not use chemicals for cleaning (petrol, paint thinner, etc. Z Do not apply oil to the inside of the unit. [. . . ]