User manual SHARP XL-DAB20NH

[. . . ] Bei Einstellung der ON/STAND-BY-Taste auf STAND-BY ist die Netzspannung immer noch im Gerät vorhanden. Wenn die ON/STAND-BY-Taste auf STAND-BY eingestellt wird, kann das Gerät unter Verwendung der Timer-Betriebsart oder Fernbedienung in Betrieb gesetzt werden. Warnung: In diesem Gerät sind keine vom Benutzer wartbaren Teile vorhanden. Niemals Abdeckungen entfernen, außer wenn Sie dafür qualifiziert sind. [. . . ] 6 - 8 References Troubleshooting chart . 22 CD or MP3/WMA disc Playback Listening to a CD or MP3/WMA disc . 8 - 9 Advanced CD or MP3/WMA disc playback . 9 - 10 MP3/WMA folder mode (only for MP3/WMA files) . 11 E-1 Precautions General Do not remove the outer cover, as this may result The ventilation should not be impeded by covering the Please ensure that the equipment is positioned in a in electric shock. Refer internal service to your local SHARP service facility. well ventilated area and ensure that there is at least 10 cm (4") of free space along the sides, top and back of the equipment. 10 cm (4") 10 cm (4") 10 cm (4") 10 cm (4") Use the unit on a firm, level surface free from vibration. Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generate electrical noise. Do not place anything on top of the unit. Do not expose the unit to moisture, to temperatures higher than 60°C (140°F) or to extremely low temperatures. If your system does not work properly, disconnect the AC power lead from the wall socket. Position the AM loop aerial for optimum reception. Place the AM loop aerial on a shelf, etc. , or attach it to a stand or a wall with screws (not supplied). Note: Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception. The iPod with photo and video can be viewed by connecting to a TV/monitor. If the TV/monitor has a video input, connect it to the VIDEO OUT socket on the rear of the unit. Note: Please make sure to set iPod unit to either NTSC or PAL to match your TV signal. Please visit Apple's home page for further information. AC power connection After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket. If you plug in the unit first, the unit will enter the stand-by mode. Note: Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time. Speaker connection (­) terminal, and the red wire to the plus (+) terminal. Connect the black wire to the minus Use speakers with an impedance of 6 ohms or more, as lower impedance speakers can damage the unit. Do not mistake the right and the left channels. The right speaker is the Incorrect one on the right side when you face the unit. [. . . ] Is the AC power lead of the unit plugged in? The video cable is not properly connected. The TV/monitor's input selection is not properly set. iPod will not Wrong iPod adaptor is used. [. . . ]