User manual SHARP XL-DAB257NH

[. . . ] The illustration printed in this operation manual are for the model XL-DAB227NH. MICRO COMPONENT SYSTEM MODEL XL-DAB227NH XL-DAB227NH XL-DAB257NH OPERATION MANUAL AUDIO IN XL-DAB257NH iPod is a trademark of Apple Inc. , registered in the U. S. and other countries. AUDIO IN XL-DAB227NH XL-DAB257NH Special notes NOTES FOR USERS IN THE U. K. AND IRELAND The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used. [. . . ] To cancel random play: Press the PLAY MODE button. The tracks on the disc can be played in random order automatically. To random play all tracks: Press and hold down PLAY MODE button on the remote control. Press the / button. 21 CD or MP3/WMA disc Playback XL-DAB227NH XL-DAB257NH Advanced CD or MP3/WMA disc playback (continued) Notes: If you press the button during random play, you can move to the track selected next by the random operation. On the other hand, the button does not allow you to move to the previous track. The beginning of the track being played will be located. In random play, the unit will select and play tracks automatically. (You cannot select the order of the tracks. ) 5 6 Press the (CD ) button. Press the / button to start playback. CD or MP3/WMA disc Playback Caution: After performing repeat or random play, be sure to press the (CD ) button. Otherwise, the disc will play continuously. Programmed play You can choose up to 32 selections for playback in the order you like. To clear the programmed selections: Press the CLEAR/DIMMER button on the remote control whilst the "MEMORY" indicator is flashing. Each time the button is pressed, one track will be cleared, beginning with the last track programmed. To cancel the programmed play mode: Whilst in the stop mode and the "MEMORY" indicator is lit, press the CLEAR/DIMMER button on the remote control. The "MEMORY" indicator will disappear and all the programmed contents will be cleared. Adding tracks to the programme: If a programme has been previously stored, the "MEMORY" indicator will be displayed. The new tracks will be stored after the last track of the original programme. To check which tracks are programmed: Whilst the unit is stopped in the programmed play mode, press the or button. MP3/WMA folder programmed: Only tracks in the same folder can be select. Select which folder to be progammed before entering programme mode. (refer page 24 to select folder) Notes: When a disc ejected, the programme is automatically cancelled. Even if you press the ON/STAND-BY button to enter the stand-by mode or change the function from CD to another, the programmed selections will not be cleared. During the programme operation, random play is not possible. 1 Whilst in the stop mode, press the MEMORY button on the remote control to enter the programming save mode. 2 Press the direct search buttons on the remote control to select the desired track. Selected track number You can also select a track by pressing the or button. 3 4 Press the MEMORY button to save the track number. [. . . ] Whilst pressing down the button, press the CD button until "CLEAR ALL" appears. Maintenance Cleaning the CD pickup lens In order to ensure proper operation of the CD player, preventative maintenance (cleaning of the laser pickup lens) should be performed periodically. Lens cleaners are commercially available. Contact your local CD software dealer for options. Cleaning the cabinet Caution: This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme. Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth. [. . . ]