User manual SHARP XL-E15H

[. . . ] MICRO COMPONENT SYSTEM MIKROWIEA MIKROSYSTÉM MODEL MODEL MODEL XL-E15H OPERATION MANUAL INSTRUKCJA OBSLUGI NÁVOD NA POUZITÍ ENGLISH POLSKI CESKY . . . Please refer to pages i to vi and E-1 to E-16. Patrz strony od i do vi oraz od PL-1 do PL-16. Viz strany i az vi a CZ-1 az CZ-16. ENG - SPECIAL NOTES When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still present inside the unit. [. . . ] It is advisable to avoid exposure to high volume levels. Do not turn the volume on to full at switch on. Excessive sound pressure from earphones and headphones can cause hearing loss. Hold the AC power plug by the head when removing it from the wall socket, as pulling the lead can damage internal wires. The AC power plug is used as a disconnect device and shall always remain readily operable. Controls and indicators Front panel 1 MICRO COMPONENT SYSTEM XL-E15 ON/ STAND-BY 2 3 4 5 6 7 REMOTE SENSOR 8 9 10 11 12 13 14 PRESET PHONES AUDIO IN Reference page 1. Disc Track Down or Fast Reverse, Tuner Preset Down, Time Down Button . Disc Track Up or Fast Forward, Tuner Preset Up, Time Up Button. 14 E-2 Controls and indicators (continued) Display 1 2 3 45 Reference page 1. 12 6 Rear panel Reference page 1. Speaker Wire 2 1 3 Remote control 1 10 2 3 4 5 6 7 8 11 12 13 14 15 16 9 17 18 19 20 Reference page 1. Disc Track Down or Fast Reverse, Tuner Preset Down, Time Down Button . Disc Track Up or Fast Forward, Tuner Preset Up, Time Up Button . 6 E-3 System connections Make sure to unplug the AC power lead before making any connections. Aerial connection (see page 4) AM loop aerial Right speaker FM aerial Left speaker Speaker connection (see page 5) AC power connection (see page 5) Wall socket (AC 220 - 240 V ~ 50/60 Hz) Aerial connection Attached FM aerial: Position the FM aerial wire in the direction where the strongest signal can be received. Supplied AM loop aerial: Connect the AM loop aerial to the AM loop aerial socket. Position the AM loop aerial for optimum reception. Place the AM loop aerial on a shelf, etc. , or attach it to a stand or a wall with screws (not supplied). Note: Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception. Installing the AM loop aerial: < Assembling > < Attaching to the wall > Wall Screws (not supplied) E-4 System connections (continued) Speaker connection Connect the black wire to the minus (­) terminal, and the red wire to the plus (+) terminal. Remote control Battery installation 1 Open the battery cover. 2 Insert the supplied batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them towards the battery terminals. 3 Close the cover. Red Black Caution: Use speakers with an impedance of 4 ohms or more, as lower impedance speakers can damage the unit. Do not mistake the right and the left channels. The right speaker is the one on the right side when you face the unit. [. . . ] Caution: This operation will erase all data stored in memory including clock, timer setting, tuner preset and CD programme. 1 2 Factory reset, clearing all memory Press the ON/STAND-BY button to enter the power stand-by mode. Press and hold TUNING/FOLDER and press ON/STAND-BY button on main unit. "RESET" appear. Before transporting the unit Remote control Symptom The remote control does not operate. [. . . ]