User manual SHARP XL-HF151PHS

[. . . ] Hnvisa till sidorna i till viii och V-1 till V-22. Leggere le pagine i a viii e I-1 a I-22. Raadpleeg de bladzijden i t/m viii en N-1 t/m N-22. Favor consultar as pginas i a viii e P-1 a P-22. [. . . ] When an external FM aerial is used, disconnect the supplied FM aerial wire. Supplied AM loop aerial: Connect the AM loop aerial to the AM terminal. Position the AM loop aerial for optimum reception. Place the AM loop aerial on a shelf, etc. , or attach it to a stand or a wall with screws (not supplied). Note: Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception. Connect the black wire to the minus () terminal, and the red wire to the plus (+) terminal. Use speakers with an impedance of 4 ohms or more, as lower impedance speakers can damage the unit. Do not mistake the right and the Incorrect left channels. The right speaker is the one on the right side when you face the unit. Do not let the bare speaker wires touch each other. Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs. Keep the remote control away from moisture, heat, shock, and vibrations. Test of the remote control Check the remote control after checking all the connections. Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below: Remote sensor Main unit 0. 2 m - 6 m (8" - 20' ) To select Line In function: On main unit: Press FUNCTION button repeatedly until Line In is displayed. On remote control: Press AUDIO/LINE (INPUT) button repeatedly until Line In is displayed. RRMCGA225AWSA RRMCGA225 E-5 General control Volume Illuminator X-Bass control When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and "X-BASS" will appear. To cancel the extra bass mode, press the X-BASS button on the remote control. Bass control 1 Press the BASS/TREBLE button to select "BASS". 2 Within 5 seconds, press the VOLUME (+ or ) button to adjust the bass. RRMCGA225AWSA Treble control 1 Press the BASS/TREBLE button to select "TREBLE". 2 Within 5 seconds, press the VOLUME (+ or ) button to adjust the treble. To turn the power on Press the ON/STAND-BY button to turn the power on. After use: Press the ON/STAND-BY button to enter the power stand-by mode. Equaliser Flat No equalization. [. . . ] The TV/monitor's input selection is not properly set. The iPod TV out feature has not been set to output video. The iPod or iPhone is not making full contact with the connector. Caution: This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme. Symptom No sound is produced. [. . . ]