User manual SHARP XL-UH25H

[. . . ] MIKRO KOMPONENTEN SYSTEM MICRO-CHANE SISTEMA MICRO MIKRO KOMPONENT SYSTEM MICRO SISTEMI MICRO SYSTEEM SISTEMA DE MICRO COMPONENTE MICRO COMPONENT SYSTEM MODELL MODLE MODELO MODELL MODELLO MODEL MODELO MODEL Mikro Komponenten System XL-UH25H besteht aus XL-UH25H (Hauptgert) und CP-UH25H (Lautsprechersystem). Micro-chane XL-UH25H compose de XL-UH25H (appareil principal) et CP-UH25H (enceinte acoustique). Sistema micro componente XL-UH25H que consta de XL-UH25H (aparato principal) y CP-UH25H (sistema de altavoces). XL-UH25H mikro komponent system bestende av XL-UH25H (huvudenhet) och CP-UH25H (hgtalarsystem). [. . . ] Battery removal: Open the battery cover and pull up the battery to take out. External FM aerial 75 ohms coaxial cable Note: When an external FM aerial is used, disconnect the supplied FM aerial wire. E-8 Preparation for Use XL-UH25H Remote control (continued) Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs. Keep the remote control away from moisture, heat, shock, and vibrations. General control ENGLISH Test of the remote control Preparation for Use Check the remote control after checking all the connections (see pages 6 - 8). Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below: Press the ON/STAND-BY button. Remote sensor To turn the power on Press the ON/STAND-BY button to turn the power on. After use: 0. 2 m - 6 m (8" - 20') Press the ON/STAND-BY button to enter the power stand-by mode. Display brightness control To dim the display brightness, hold down the CLEAR/DIMMER button on the remote control for 2 seconds or more during power on. Volume auto fade-in If you turn off and on the main unit with the volume set to 27 or higher, the volume starts at 16 and fades in to the last set level. Volume control Main unit operation: When the VOLUME control is turned clockwise, the volume will increase. When it is turned anti-clockwise, the volume will decrease. E-9 General control (continued) Remote control operation: Press the VOLUME (+ or ) button to increase or decrease the volume. MIN . . . . . 30 MAX Setting the clock (Remote Control only) XL-UH25H ENGLISH Extra bass control (X-BASS) When the power is first turned on, the unit will enter the extra bass mode which emphasises the bass frequencies, and "X-BASS" will appear. To cancel the extra bass mode, press the X-BASS/DEMO button on the remote control. Bass control 1. Press the BASS/TREBLE button to select "BASS". Within 5 seconds, press the VOLUME (+ or ) button to adjust the bass. -3 +3 In this example, the clock is set for the 24-hour (0:00) display. 1 2 3 Press the ON/STAND-BY button to turn the power on. Press the or button to select "TIME ADJ", and press the MEMORY button. Treble control 1. Press the BASS/TREBLE button to select "TREBLE". Within 5 seconds, press the VOLUME (+ or ) button to adjust the treble. -3 +3 4 Press the or button to select 24-hour or 12-hour display and then press the MEMORY button. Function When the FUNCTION button on main unit is pressed, the current function will change to different mode. Press the FUNCTION button repeatedly to select desired function. CD TUNER AUDIO IN USB Note: The backup function will protect the memorised function mode for a few hours should there be a power failure or the AC power lead becomes disconnected. "0:00" "AM 12:00" "AM 0:00" The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. [. . . ] Carrying the unit with USB memory device left docked might damage both the unit and the USB memory device. Care of compact discs Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player. Do not write on either side of the disc, particularly the non-label side from which signals are read. Keep your discs away from direct sunlight, heat, and excessive moisture. [. . . ]