User manual SHARP XL60 OPERATION MANUAL PART FROM THE SERVICE MANUAL

[. . . ] PREPARATION FOR USE SETTING THE CLOCK (Main unit operation) In this example, the clock is set for the 24-hour (0:00) system. XL-60H/70H s Remote control 6 Press the MEMORY/SET button. 0. 2m - 6m (8" - 20") MEMORY/SET CLOCK/TIMER/ SLEEP Jog dial 7 Adjust the minutes by turning the jog dial. 15 15 Notes concerning use: q Replace the batteries if the operating distance is reduced or if the operation becomes erratic. q Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth. q Exposing the sensor on the main unit to strong light may interfere with operation. [. . . ] When the AC power supply is restored, the clock display will flash on and off to indicate the time when the power failure occurred or when the AC power lead was disconnected. If this happens, follow the procedure below to change the clock time. To change the clock time: Perform steps 1, 2 and 4 - 8 above. To change the time display mode: 4 Press the MEMORY/SET button. Caution: q The operation explained above will erase all data stored in memory, such as clock and timer settings, and tuner and CD presets. 1 Perform steps 1 - 3 in the section "RESETTING THE MICROCOMPUTER", . 5 Adjust the hour by turning the jog dial. 2 Perform steps 1 - 8 above. q When the jog dial is turned one click clockwise, the time will increase by 1 hour. When it is turned one click anti-clockwise, the time will decrease by 1 hour. Keep turning the jog dial to change the time continuously. q When the 12-hour display is selected, "AM" will change automatically to "PM". XL-60H/70H 1 Check the supplied accessories 5 Listening to a CD 4 Label side up 3 OPEN/CLOSE 1 2 3 Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "CD" or "NO DISC" appears. Press the OPEN/CLOSE button to open the CD compartment. Close the CD compartment by pushing the OPEN/CLOSE button. Adjust the VOLUME control. Remote control × 1 AM loop aerial ×1 5 (For U. K. ) FM aerial × 1 1 (For Europe) AC power lead × 1 4 5 6 7 6 7 2 2 Putting batteries into the remote control 2 Insert the batteries. 3 Replace the battery cover. 6 Listening to a tape 1 1 2 4 5 Press the ON/STAND-BY button to turn the power on. Press the FUNCTION button until "TAPE" appears. Press the button. 1 Remove the battery cover. 2 3 4 5 q 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar) 3 Adjust the VOLUME control. Placing the system 10 cm (4") 10 cm (4") 20 cm (8") 10 cm (4") 3 7 1 Listening to the radio 1 Press the ON/STAND-BY button to turn the power on. [. . . ] Unplug the AC power lead from the AC INPUT socket on this unit. Whilst pressing down the MEMORY/SET button and the button, plug the AC power lead into the AC INPUT socket on this unit. AC 230 V, 50 Hz (For U. K. ) 2, 3 Caution: q The operation explained above will erase all data stored in memory, such as clock and timer settings, and tuner and CD presets. AC 230 V, 50 Hz (For Europe) q CD pickup cleaning q Do not touch the laser pickup lens. If fingerprints or dust accumulate on the pickup, clean it gently with a dry cotton swab. 3 Connect the AC power lead. ­7­ [. . . ]