User manual SHARP XVZ90E CHAPTER 4 - BASIC OPERATION

[. . . ] Using the Menu Screen Basic Operations This projector has two sets of menu screens that allow you to adjust the image and various projector settings. These menu screens can be operated from the projector or the remote control with the following procedure. 1, 7 64 2, 3, 5 On-screen Display INPUT 1 (COMPONENT) or 2 (COMPONENT or analog RGB) mode INPUT 3 or 4 (VIDEO) mode 1 2 1 2 Basic Operation 3 3 4 1 Press MENU. The "Picture" menu screen for the selected INPUT mode appears. 2 Press / to display the other menu screen, if you want. [. . . ] Adjust the settings described on pages 29 to 31. The values that are adjusted are stored. 5 To exit the menu screen, press MENU. -32 Adjusting the Computer and DVD/DTV Images When displaying computer patterns which are very detailed (tiling, vertical stripes, etc. ), interference may occur between the DMD pixels, causing flickering, vertical stripes, or contrast irregularities in portions of the screen. Should this occur, adjust "Clock", "Phase", "H-Pos" and "V-Pos" for the optimum computer image. 2, 3, 4 1, 5 Description of Adjustment Items Selected item Clock Phase H-Pos V-Pos Reset Description Adjusts vertical noise. Adjusts horizontal noise (similar to tracking on your VCR). Centres the on-screen image by moving it to the left or right. Centres the on-screen image by moving it up or down. All computer image adjustment items are returned to the factory preset settings. On-screen Display 2 · "Clock", "Phase", "H-Pos" and "V-Pos" cannot be used in the component mode. · Computer image adjustments can be made easily by pressing AUTO SYNC ( ) on the remote control. See page 35 for details. 1 Press MENU. The "Picture" menu screen appears. 3 Press / to display the "Fine Sync" menu to select a specific adjustment item. 4 Press / to move the mark of the selected adjustment item to the desired setting. Basic Operation 5 To exit the menu screen, press MENU. 3 · To reset all adjustment items, select "Reset" on the "Fine Sync" menu screen and press ENTER. · The adjustable area of each item may be changed according to the input signal. -33 Adjusting the Computer and DVD/DTV Images Special Modes Adjustment Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, the optimal resolution mode in "Special Modes" on the "Fine Sync" menu screen may need to be selected to match the computer display mode. The "Picture" menu screen appears. 3 Press press 4 Press On-screen Display / 2, 3, 4 5 to display the "Fine Sync" menu to select "Special Modes", and then to select the optimal resolution. . / 5 Press ENTER to save the setting. 6 To exit the menu screen, press MENU. · Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see. ) · When inputting DTV 1080I signal, select the corresponding type of signal in step 4 above. · When inputting 720P RGB signal, select the corresponding type of signal in step 4 above. Basic Operation Checking the Input Signal This function allows you to check the current input signal information. The "Picture" menu screen appears. [. . . ] / to display the "Options" menu screen. to select "Menu Position", and then to select the desired menu position. 5 Press ENTER to save the setting. 6 To exit the menu screen, press MENU. Selecting the Menu Colour This function allows you to select the colour of the menu screen. Basic Operation Description of Menu colour Selected item Opaque ( ) Description The menu is displayed opaquely. The part of the menu on the image becomes transparent. 2, 3, 4 1, 5 Translucent ( ) 1 Press MENU. [. . . ]