User manual SHARP Z-25

[. . . ] 1 2 3 4 5 6 7 8 9 10 Exposure indicators Dr um replacement required indicator Misfeed indicator Toner required indicator Copy ratio indicators Zoom indicator Copy ratio display key Copy quantity display *1 Power save indicator Exposure mode selector key and indicators 11 12 13 14 15 16 17 18 19 20 Light key Dark key Tray select key and indicators Copy ratio selector key Zoom keys Copy quantity keys Clear key *2 Print key and ready indicator SPF indicator SPF misfeed indicator This copier has been designed to provide intuitive operating ease while requiring a minimum amount of space. Space conservation with a fixed platen and a frontloading tray; · Power savings with preheat and auto power shut-off modes; · NOTE: The Z-830 and the Z-845 are equipped with a bypass tray for multiple sheet feeding, while the Z-810 is equipped with a single-sheet bypass. Remarks which apply only to the Z-810 are noted with 5Z-810. the Z-845 has a single pass original feeder (SPF). [. . . ] For best results, use only Sharp recommended paper and transparency film. 5 Z-810 Insert a single sheet of paper into the feed slot. For multiple sheet copying, set the number of copies and then press the print (z) key. NOTE: If blinks in the copy quantity display when using the bypass tray, see "Blinking " paragraph on page 3-13. Colour TD cartridges (sold separately) can be installed to copy one colour at a time. Multiple colours can be copied on the same page by changing the colourTD cartridge and recopying on the same copy paper. To order colourTD cartridges, use the part codes given below. The standard life of a cartridge for A4 size originals is given below. Black (ZT-81TD1) 4, 000 copies at 5% toned area Red (ZT-81TD2) 3, 000 copies at 5% toned area Blue (ZT-81TD3) 3, 000 copies at 5% toned area Farbentwicklereinheiten (separat erhältlich) können eingebaut werden, um Kopien mit jeweils einer Farbe auszuführen. Replace the first original with the second original on the document glass. Feed the copy face up from the bypass tray to copy an additional colour, use the TRAY SELECT (M) key to select the bypass tray, and press the print (z) key. Make sure the edges go under the corner hooks. Do not load paper above the maximum height line. Check the paper guides and adjust them again if necessary. Push the paper tray firmly back into the copier. To cancel the blinking : without restarting copying, press the clear (>) key. If a misfeed occurs in the paper tray or in the bypass area : will blink in the copy quantity display. If paper is accidentally torn during removal, be sure to remove all pieces. If the misfed paper is stuck in the fusing area, lift the fusing unit lever to remove a misfeed in the fusing area (see below). Gently push down the upper half of the copier to close it. Blinking : If the bypass tray becomes empty during copying or paper has not been fed correctly in the bypass tray, : will blink in the copy quantity display. If copy paper is jammed in the bypass tray, either gently pull out the misfed paper or open the copier and remove it. [. . . ] Enter a program number using the left copy quantity (<) key. The selected program number will blink in the copy quantity display. If a mistake is made in steps 2 to 4, press the clear (>) key. Program name Auto clear time Preheat mode Auto power shut-off mode The entered program number will be steadily lit on the left side of the copy quantity display and the currently selected parameter number for the program will blink on the right side. [. . . ]