User manual SHARP Z-830

[. . . ] The carton and packing can be reused for transporting the machine, should it be necessary. The carton and packing can be reused for transporting the machine, should it be necessary. 1 2 3 4 5 6 7 8 Document cover Document glass Operation panel Exit tray Single bypass guides Single bypass Drum cartridge Power switch 9 10 11 12 13 14 15 16 Bypass tray guides Bypass tray Release lever* TD Cartridge Fusing unit Transfer corona Transfer corona cleaner Fusing unit lever 17 SPF exit tray 18 Original guides 19 SPF tray * Do not press this lever during copying *1 When the copy ratio display key or a zoom key is pressed, the copy ratio will appear in the copy quantity display. *2 To display the total number of copies, press the clear (>) key for approximately 5 seconds when "0" is displayed in the copy quantity display. [. . . ] Up to three colours can be copied on a single sheet of paper. The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from document glass or from the SPF (Z-845 only). NOTE: Z-845 only When using document glass remove original from SPF tray. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up. Press the light ({) or dark (}) key to lighten or darken the automatic exposure level as desired. This automatic exposure level will remain in effect until you change it again by this procedure. Selection of this mode does not affect the photo (6) mode. Follow the procedure below for setting the toning level. To enter the toner save mode, press the light ({) key. The exposure indicator marked "1" will light up, indicating the toner save mode is selected. To return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. : will blink in the copy quantity display when the paper tray or the bypass tray is empty (Z-830/Z-845 only) or when the paper has not been fed all the way in. Copy paper of A5 and A4 sizes in the weight range of 56 to 80 g/m2 can be used. Gently lift and pull out the paper tray. NOTE: If paper has misfed from the tray, push back the tray and refer to the instructions on the next page for misfeed removal. Push the pressure plate until it locks in position. Adjust the paper guides on the tray to the copy paper width and length. Move the left guide to the appropriate slot as marked on the tray. Squeeze the lever of the front guide and slide the guide to match with the width of the paper. Fan the copy paper and insert it into the tray. Make sure the edges go under the corner hooks. [. . . ] Select the desired parameter using the right copy quantity (<) key. The entered parameter number will blink on the right of the copy quantity display (see next page for parameter table). Factory default settings are indicated with an asterisk (*). The right-hand number in the copy quantity display will be steadily lit and the entered value will be stored. [. . . ]