User manual SHERWOOD CD-772

[. . . ] Introduction READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FCC INFORMATION(FOR U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] 19 5 Rear Panel Connections · Do not plug the AC input cord into the wall AC outlet until all connections are completed. · Be sure to connect the white plugs to the L(Left) and the red plugs to the R(Right) jacks when making connections with the supplied cords. · Refer to the connecting diagram in the operating insructions of your amplifier/receiver. 1. Connecting AUDIO OUTPUT jacks Connect these jacks to CD (or AUX) INPUT jacks of your amplifier/receiver. Connecting DIGI-LINK jack Connect this jack to the DIGI-LINK jack of Sherwood system amplifier/receiver such an RX-772, etc. to control this unit remotely by DIGI-LINK system. (For details, refer to the operating instructions of Sherwood amplifier/receiver. ) § Note : · The DIGI-LINK operation may not work on some Sherwood components. Connecting OPTICAL DIGITAL OUTPUT jack Connect this jack to the OPTICAL DIGITAL INPUT jack of your amplifier/receiver to enjoy live digital sound. § Notes : · It is not recommended to record digital audio signals with digital audio connection between this unit and MD and CD recorder, etc. When recording the sounds played on this unit, record them through the AUDIO OUTPUT jacks. · All of the commercially-available optical fiber cords cannot be used for audio components. If there is an optical fiber cord which cannot be connected to your components, consult your dealer or nearest service organization. AC INPUT Plug the supplied AC input cord into this AC input and then into the wall AC outlet. § Note : · Do not use an AC input cord other than the one supplied with this unit. The AC input cord supplied is designed for use with this unit and should not be used with any other device. 6 Front Panel & Remote Controls Front Panel Controls Remote Controls 7 1. POWER SWITCH Push this switch to turn the power on and to enter the operating mode. To switch the power off, push again this switch. 10. DIMMER BUTTON Press this button to select the brightness of the fluorescent display as desired. 2. DISC TRAY Load a disc on the disc tray. 11. DISPLAY BUTTON Press this button to display the different time information on the audio CD or the different name information, etc. NUMERIC (0~9) BUTTONS Press the corresponding buttons to select a track for play or programming. 5. RANDOM PLAY BUTTON Press this button to play tracks in random order. Press this button to open or to close the disc tray. ) BUTTON 14. [. . . ] · Poor connections. · Check the connections and connect all cords securely. · Place this unit on a stable surface. Sound skips · Defective or deeply scratched disc. · This unit is placed on a surface that is subject to vibration or physical shock. · The disc is dirty or badly scratched. [. . . ]