User manual SHERWOOD RD-6504

[. . . ] cover_6504:cover_6504 2009-02-12 9:46 2 OPERATING INSTRUCTIONS BEDIENUNGSANLEITUNG INSTRUCCIONES DE FUNCIONAMIENTO MODE D'EMPLOI RD6504 AUDIO/VIDEO RECEIVER AUDIO/VIDEO RECEIVER RECEPTOR DE AUDIO/VIDEO RECEPTEUR AUDIO/VIDEO / RD-6504(G):RD-6504(G) 2009-02-12 9:35 2 Introduction READ THIS BEFORE OPERATING YOUR UNIT ENGLISH This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Caution regarding installation Note : For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure. Do not block ventilation openings or stack other equipment on the top. FOR YOUR SAFETY Units shipped to Australia are designed for operation on 230 V AC only. To ensure safe operation, the three-pin plug supplied must be inserted only into a standard three-pin power point which is effectively earthed through the normal household wiring. Extension cords used with the equipment must be three-core and be correctly wired to provide connection to earth. [. . . ] · While listening to FM radio broadcasts, press and hold down the (MEMORY/) ENTER button for more than 2 seconds. 2. Press the TUNING UP(+)/DOWN(-) buttons for more than 0. 5 second. or · The tuner will now search until a station of sufficient strength has been found. The display shows the tuned frequency and "TUNE". · If the station found is not the desired one, simply repeat this operation. · Weak stations are skipped during auto tuning. · Then "AUTO MEM" flickers and this receiver starts auto presetting. · To stop auto presetting, press this button again. · Up to 30 FM stations can be stored. Notes: · FM stations of weak strength cannot be memorized. · To memorize AM stations or weak stations, preform "Manual presetting" procedure with using "Manual tuning" operation. 23 ENGLISH 1. Select the desired band. RD-6504(G):RD-6504(G) 2009-02-12 9:35 24 Manual presetting · You can store up to 30 preferred stations in the memory. Tuning to preset stations · After selecting the tuner as an input source, select the desired preset number. 1. Tune in the desired station with auto or manual ENGLISH tuning. 2. Press the (MEMORY/)ENTER button. or · When using the NUMERIC buttons on the remote control. Examples) For "3" : MEM For "15" : For "30" : · "MEM" is flickering for several seconds. 3. Select the desired preset number (1~30) and press the (MEMORY/)ENTER button. · When using the NUMERIC buttons on the remote control. Examples) For "3" : For "15" : For "30" : · The station has now been stored in the memory. · When using the NUMERIC buttons, the station is stored automatically without pressing the (MEMORY/)ENTER button. · A stored frequency is erased from the memory by storing another frequency in its place. · If "MEM" goes off, start again from the above step 2. 4. Repeat the above steps1 to 3 to memorize other stations. MEMORY BACKUP FUNCTION The following items, set before the receiver is turned off, are memorized. · INPUT SELECTOR settings · Surround mode settings · Preset stations, etc. 24 RD-6504(G):RD-6504(G) 2009-02-12 9:35 25 RDS Tuner (Regional Option for some countries in Europe, etc. ) LISTENING TO RDS BROADCASTS(FM ONLY) ENGLISH RDS(Radio Data System) is a method for sending information signals together with the transmitter signals. Your tuner is capable of translating these signals and putting the information on the display. These codes contain the following informations. [. . . ] -15 ~ -21 dBm VIDEO SECTION · Video format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PAL · Input sensitivity (=Output level) , 75 Video (Composite (normal)) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Vp-p Component video (R-Y signal) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 5 Vp-p (B-Y signal) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]