User manual SHERWOOD RD-8504

[. . . ] cover_8504:cover_8504 2009-11-04 2:34 1 RD-8504 RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18 6:412 IMPORTANT SAFETY INSTRUCTIONS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] While displaying a category name, select the desired category, then press the ENTER button. ENGLISH 1. In the SIRIUS mode, press the SEARCH MODE button to select the direct search mode, then press the ENTER button. · Each time the SELECT </> buttons are pressed, one of different categories is selected. · When a category name disappears, repeat again from the above step 1. · Each time the SEARCH MODE button is pressed, the search mode changes as follows: DIR SRCH CAT SRCH OFF (Direct search) (Category search) 3. While displaying the selected category, select the desired channel. · Then "SR - - -" is displayed. 2. While displaying "SR - - -", select the desired channel number with pressing the NUMERIC (0~9) buttons. Examples: For "3" : For "27" : For "124" : · You can store up to 30 preferred channels in the memory. · When "SR - - -" disappears, repeat again from the above step 1. Presetting channels 1. Select the desired channel with preforming channel search, direct search or category search. Category search · Category search allows you to select the desired channel by the selected category. 2. To memorize the channels, perform the steps 2 to 4 in "Manual presetting" procedure on page 30. 1. In the SIRIUS mode, press the SEARCH MODE button to select the category search mode, then press the ENTER button. Preset search · In the SIRIUS mode, select the desired preset channel. · Then a category is displayed. 32 RD-8504(A)_ENG_091118:RD-8504(A)2009-11-18 6:4133 Displaying SIRIUS information · You can display SIRIUS information such as channel name, artist name, song title and signal strength. · In the SIRIUS mode, Parental lock · You can lock the channels that you do not want to receive or unlock the previously locked channels. When tuning in the previously locked channels. Tune in the channels to which the parental lock is applied by performing direct search or preset search only. · Then "CODE " is displayed for several seconds. While displaying "CODE ", input the password (4-digit number) with using the NUMERIC (0~9) buttons. · Each time the DISPLAY button is pressed, the display mode changes as follows: Channel name Song title Artist name Composer name Volume Surround mode Signal input Signal strength Category ("EXCEL(LENT)", "GOOD", "WEAK", "NO SIG(NAL)") Note: · If the information on artist name, song title or category, etc. is not available, it will not be displayed correctly. Signal strength display mode · If the reception is poor, you can check the signal strength of the SIRIUS Satellite Radio signal and adjust the position of the SiriusConnect Home antenna until "EXCEL(LENT)" is displayed. Error message and status · If an operation takes longer than usual or an error occurs, one of the following messages may be displayed. Message ANTENNA UPDATING SUB-UPDT (updated) NO SIG(NAL) Status The SiriusConnect Home tuner is not connected properly. Displayed while the encoding code is being updated. Displayed while updating contract information. Reposition your SiriusConnect Home Tuner antenna. LINKING CHECK SR TUNER The selected channel is not currently broadcasting. [. . . ] · Center speaker setting is "No". · Master volume and center level are too low. · The input signal format or the current surround mode cannot support the 7. 1(or 6. 1) surround. · The surround back channels' power amplifier is assigned to "Bi AMP" or "Room 2". [. . . ]