User manual SHERWOOD RV-4060

[. . . ] OPERATINGINSTRUCTIONS AUDIO/VIDEO RECEIVER RV-4060R REMOTE SENSOR VOLUME/TONE/BALANCE POWER STANDBY/OFF STANDBY VOL FM AM AUTO MEMO MHz STEREO KHz MONO MUTE TAPE M TEST VIDEO12 SLEEP CH NR WI PH PRO LOGIC BASS TREBLE 3-STEREO BALANCE PHONES MEMORY MODE TUNING/PRESET RESET TAPE MONITOR SURROUND VCR 2/CAMCORDER INPUT FM AM VCR 1 VCR 2 TV/AUX CD VIDEO L -AUDIO- R RV-4060R AUDIO/VIDEO RECEIVER INTRODUCTION UNPACKING AND INSTALLATION READ THIS BEFORE OPERATING YOUR UNIT FOR U. S. A. AND CANADA 120 V ENGLISH Congratulations on Your Purchase! Your new high fidelity Receiver is designed to deliver maximum enjoyment and years of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help ensure a trouble free installation. [. . . ] PRESET SCAN ­ for scanning the stations memorized . ­ for starting reverse or forward side play. / ­ for adjusting the volume. 16. REPEAT A< >B ­ for repeating a specific passage. INTRO ­ to preview each track only for 10 seconds. PRESET ­ for selecting equalizer pattern. USER ­ for adjusting equalizer pattern as desired. TAPE MON ­ for monitoring the sound of recording or playback of cassette deck. FILE ­ for selecting desired equalizer pattern in the preset or user mode. 19. DECK SELECTOR A, B ­ for selecting deck A or B. ­ for recording. In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD or Deck, CD or TAPE MONITOR is selected automatically without selecting the input and PLAY, etc. POWER ­ for power control of this receiver or system. (as described in amplifier chapter titled "POWER STANDBY/ON). COMPACT DISC PLAYER AMPLIFIER POWER ON/OFF ENGLISH Press the POWER switch to turn the power on. ­ The receiver enters the operating mode and the respective indicators lights up. To turn the power off, press the POWER switch again. ­ The power is cut off and the respective indicators lights off. POWER STANDBY/ON In the operating mode, press the POWER button on the remote control. ­ The receiver enters the standby mode, the respective indicators light off and the standby indicator lights up. In the standby mode, the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness. ­ If the electricity fails or the AC cord is leaved unplugged for more than 2 weeks(power off mode), the memorized contents are all cleared. In the standby mode, press the POWER button on the remote control. [. . . ] ­ Surrounding area causing interference. Lengthen or elevate antenna. PRESET STATIONS CANNOT BE RECEIVED ­ Speaker cables are disconnected. Adjust the volume. NO SOUND FROM THE REAR SPEAKERS ­ An incorrect station frequency has been memorized. ­ The memorized stations are cleared. [. . . ]