User manual SHERWOOD RX-4103

[. . . ] OPERATINGINSTRUCTIONS AM/FM STEREO RECEIVER RX-4103 DAS DISCRETE AMPLIFIER STAGE VOLUME MEMORY T/P MODE REMOTE SENSOR TONE BALANCE STANDBY TUNING/PRESET FM/AM CD TAPE TV/AUX VCR TONE DIRECT ON/STANDBY PHONES A SPEAKER B RX-4103 AM/FM STEREO RECEIVER Introduction UNPACKING AND INSTALLATION ENGLISH Congratulations on Your Purchase! Your new high fidelity receiver is designed to deliver maximum enjoyment and years of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help ensure a trouble free installation. We recommend that you save the carton and packing material. [. . . ] TUNING/PRESET UP/DOWN( BUTTONS Press these buttons to tune in the desired stations. FM MODE BUTTON Press this button to select the desired FM mode. Each time this button is pressed, the FM mode is changed to the stereo mode or the mono mode. PRESET SCAN BUTTON Press this button to scan the stations in the preset sequence. VOLUME CONTROL KNOB, UP/DOWN( ) BUTTONS Adjust the volume to a comfortable listening level with this knob or these buttons. MUTE BUTTON Press this button to temporarily mute the sound. Press again to resume the previous sound level. DISPLAY BUTTON Press this button to select the brightness of unit's display as desired. Each time this button is pressed, the brightness of unit's display changes as follows: ON dim OFF SLEEP BUTTON Press this button to activate the sleep timer for a specified period of time. Each time this button is pressed, the sleep time changes as follows: 10 20 30 60 90 OFF Unit : minutes REMOTE SENSOR This receives the signals from the remote control unit. FLUORESCENT DISPLAY For details, see the next page. 8 FLUORESCENT DISPLAY ENGLISH REMOTE CONTROL OPERATION RANGE LOADING BATTERIES 1 AM/FM STEREO RECEIVER Remove the cover. RX-4103 DAS DISCRETE AMPLIFIER STAGE VOLUME MEMORY T/P MODE REMOTE SENSOR TONE BALANCE STANDBY TUNING/PRESET TUNING/PRESET FM/AM CD TAPE TV/AUX VCR TONE DIRECT ON/STANDBY PHONES A SPEAKER B 7m 30 30 POWER A SPEAKER B 1 2 3 4 5 6 7 8 9 0 FM MODE MEMORY 2 Load two batteries matching the polarity. DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX AUDIO CONTROL TONE SEL BALANCE TREBLE /BASS MUTE VOLUME REMOTE CONTROL UNIT RM-101 Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. Remove the batteries when they are not used for a long time. Do not use the rechargeable batteries(Ni-Cd type). 9 Operations LISTENING TO A PROGRAM SOURCE ENGLISH 1 Turn the power on. STANDBY POWER POWER A SPEAKER B 1 2 3 4 4 5 DOWN Operate the selected component for playback. 5 6 7 8 9 0 FM MODE MEMORY DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX AUDIO CONTROL TONE SEL BALANCE TREBLE /BASS MUTE VOLUME ON/STANDBY or REMOTE CONTROL UNIT RM-101 Adjust the volume to a comfortable listening level. POWER A SPEAKER B The unit is turned on and enters the operating mode. To turn the power off, press the POWER button. Then it enters the standby mode and the STANDBY indicator lights up. This means that the unit is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness. In the standby mode, if an INPUT SELECTOR button is pressed, the unit is turned on automatically and the desired input is selected. 1 2 3 4 VOLUME 5 6 7 8 9 0 FM MODE MEMORY DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX AUDIO CONTROL TONE SEL VOLUME VOLUME or UP BALANCE TREBLE /BASS MUTE REMOTE CONTROL UNIT RM-101 2 A Switch the desired speakers on. POWER A SPEAKER B 1 2 3 4 A SPEAKER B 6 To mute the sound. POWER A SPEAKER B 1 2 3 4 5 6 7 8 5 6 7 8 9 0 FM MODE MEMORY 9 0 FM MODE MEMORY SPEAKER B DISPLAY SLEEP P. SCAN TUNER DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX CD TAPE VCR AUX AUDIO CONTROL TONE SEL AUDIO CONTROL TONE SEL BALANCE TREBLE /BASS MUTE VOLUME BALANCE TREBLE /BASS MUTE VOLUME or MUTE REMOTE CONTROL UNIT RM-101 REMOTE CONTROL UNIT RM-101 Then the corresponding speaker indicator lights up and the sound can be heard from the speakers connected to the selected speaker terminals. When using the headphones for private listening, press the corresponding SPEAKER button to switch off both A and B speakers. "MUTE" lights up and "SPEAKER" flickers. To resume the previous sound level, press this button again. 3 Select the desired input source. FM/AM CD TAPE TV/AUX VCR 7 POWER A SPEAKER B To listen with the headphones. PHONES 1 2 3 4 TUNER 5 6 7 8 9 0 FM MODE MEMORY DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX or AUDIO CONTROL TONE SEL CD TAPE VCR AUX BALANCE TREBLE /BASS MUTE VOLUME REMOTE CONTROL UNIT RM-101 Each time the FM/AM button on the front panel or the TUNER button on the remote control is pressed, the band is changed to AM or FM. Be sure to switch off both A and B speakers. 10 8 Enter the tone mode. POWER A SPEAKER B POWER A SPEAKER B 1 1 2 3 4 5 5 6 7 8 9 2 3 4 6 7 8 0 FM MODE MEMORY TONE 9 0 FM MODE MEMORY DISPLAY SLEEP P. SCAN TUNER DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX CD TAPE VCR AUX AUDIO CONTROL TONE SEL AUDIO CONTROL TONE SEL or BALANCE TREBLE /BASS MUTE VOLUME TONE SEL or TREBLE /BASS BALANCE TREBLE /BASS MUTE VOLUME REMOTE CONTROL UNIT RM-101 REMOTE CONTROL UNIT RM-101 Each time this button is pressed, the corresponding tone mode is selected and shown for 5 seconds as follows: BAS(s) TRE(ble) Note: When the tone direct function is activated, the tone mode cannot be entered and "T-DIR" is displayed. If the tone display disappears, start from the step 8 again. Notes: Extreme settings at high volume may damage your speakers. In general, the bass and treble levels are adjusted to 0. 10 To listen to a program source without the tone effect. TONE DIRECT "T-DIR" is displayed and the sound that bypasses the tone circuitry will be heard. To cancel the tone direct function, press this button again to display "D-OFF". Adjusting the sound volume balance 11 Enter the balance mode. 12 Adjust the sound volume balance between the left and right speakers. POWER A SPEAKER B 1 2 3 4 5 6 7 8 9 0 FM MODE MEMORY DISPLAY SLEEP P. SCAN TUNER CD TAPE VCR AUX BALANCE AUDIO CONTROL TONE SEL or BALANCE BALANCE TREBLE /BASS MUTE VOLUME REMOTE CONTROL UNIT RM-101 "BAL" is displayed for 5 seconds. If the balance display disappears, start from the step 11 again. When the BALANCE + / - buttons on the remote control are pressed, it enters the balance mode automatically without pressing the BALANCE button on the front panel. [. . . ] 0. 05 % Intermodulation distortion 60 Hz : 7 kHz= 4 : 1 SMPTE, 8 , 105 W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 3 % Input sensitivity, 47 k Line . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV Signal to noise ratio, IHF "A" weighted Line . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 dB Frequency response Line, 20 Hz~40 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]