User manual SHERWOOD RX-770

[. . . ] Introduction READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV System Installer : This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as pracitcal. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] MEMORY BUTTON Press this button to store preset stations. TUNING/PRESET MODE BUTTON Press this button to select the tuning mode or the preset mode. NUMERIC BUTTONS(0 ~ 9) Press these buttons to select or to store preset stations directly. TUNING/PRESET UP/DOWN( BUTTONS Press these buttons to tune in the desired stations. FM MODE BUTTON Press this button to select the desired FM mode. Each time this button is pressed, the FM mode is changed to the stereo mode or the mono mode. PRESET SCAN BUTTON Press this button to scan the stations in the preset sequence. VOLUME CONTROL KNOB, UP/DOWN( ) BUTTONS Adjust the volume to a comfortable listening level with this knob or these buttons. MUTE BUTTON Press this button to temporarily mute the sound. Press again to resume the previous sound level. DIMMER BUTTON Press this button to select the brightness of the fluorescent displays as desired. Each time this button is pressed, the brightness of all fluorescent displays changes together as follows: ON dimmer OFF SLEEP BUTTON Press this button to activate the sleep timer for a specified period of time. Each time this button is pressed, the sleep time changes as follows: 10 20 30 60 90 OFF Unit : minutes CD PLAYER SECTION - to begin play - to pause play REPEAT A/B - to play a specific part repeatedly , - to skipping backward or forward - to stop play INTRO - to preview each track only for 10 seconds 8 TAPE DECK SECTION DECK SELECTOR A, B- for selecting deck A or B , - to begin reverse or forward side playback. , - to wind up the tape reversely or forwardly. - to stop playback or recording. REMOTE SENSOR This receives the signals from the remote control unit. FLUORESCENT DISPLAY FLUORESCENT DISPLAY STEREO INDICATOR TUNED INDICATOR MEMORY INDICATOR ST TUNED PRESET MEM KHz MHz SLEEP PRESET NUMBER, SLEEP TIME DISPLAY INPUT, FREQUENCY, VOLUME LEVEL, OPERATING INFORMATION, etc. REMOTE CONTROL OPERATION RANGE LOADING BATTERIES Remove the cover. 1 DAS DISCRETE AMPLIFIER STAGE ST TUNED REMOTE SENSOR PRESET MEM KHz MHz SLEEP A B POWER ON STANDBY SPEAKER DIMMER SLEEP A CD B TAPE APE AUX PHONO Load two batteries matching the polarity. REPEAT REPEA A/B CD TUNER INTRO A DECK SEL. TAPE B TREBLE + BASS 2 + T/P MUTE VOL. TUNE MEMO TUNE + FM MODE VOL. P . SCAN 1 2 3 4 5 6 7 8 9 0 REMOTE CONTROL RM 117 RM-117 AAA size) Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor. Remove the batteries when they are not used for a long time. Do not use the rechargeable batteries(Ni-Cd type). 9 Operations LISTENING TO A PROGRAM SOURCE Turn the power on. 1 STANDBY POWER ON STANDBY STANDBY POWER ON SPEAKER DIMMER SLEEP STNADBY A B TAPE AUX PHONO or CD REPEAT A/B CD TUNER INTRO ON/STANDBY A DECK SEL. TAPE B TREBLE + BASS + T/P MUTE VOL. TUNE MEMO TUNE · Then this unit is turned on to enter the operating mode. · In the operating mode, when the POWER button on the front panel or the STANDBY button on the remote control is pressed, the unit is turned off to enter the standby mode. · In the standby mode, the STANDBY indicator lights up. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness. FM MODE VOL. P . SCAN 1 2 3 4 5 6 7 8 9 0 Switch the desired speakers on. Select the desired input source. 2 POWER ON REMOTE CONTROL RM-117 3 FM/AM CD TAPE AUX PHONO CD TAPE AUX PHONO POWER ON STANDBY SPEAKER DIMMER SLEEP STANDBY STANDBY SPEAKER A SPEAKER B A B A SPEAKER DIMMER SLEEP B TAPE APE AUX PHONO A CD CD or CD TUNER REPEAT REPEA A/B INTRO TUNER B TAPE APE AUX PHONO or REPEAT REPEA A/B CD TUNER INTRO A Then the corresponding speaker indication("SPK A(or/and) B" is displayed and the sound can be heard from the speakers connected to the selected speaker terminals. When using the headphones for private listening, press the corresponding SPEAKER button to switch off both A and B speakers. DECK SEL. B TREBLE BASS T/P MUTE VOL. Each time the FM/AM button on the front panel or the TUNER button on the remote control is pressed, the band is changed to AM or FM. TUNE MEMO TUNE FM MODE VOL. P . SCAN POWER ON STANDBY SPEAKER DIMMER SLEEP A CD B TAPE VIDEO TV/AUX 4 Operate the selected component for playback. 1 2 3 4 5 6 7 8 9 0 5 DOWN Adjust the volume to a comfortable listening level. REPEAT A/B TUNER INTRO A DECK SEL. B VOLUME TREBLE + BASS + T/P MUTE VOL. REMOTE CONTROL RM-117 or UP VOL. TUNE MEMO TUNE + FM MODE VOL. P. SCAN VOL. 1 2 3 4 5 6 7 8 9 0 10 REMOTE CONTROL RM-110 POWER ON STANDBY SPEAKER DIMMER SLEEP A CD B TAPE VIDEO TV/AUX REPEAT A/B TUNER To mute the sound. INTRO To listen with the headphones. 6 A DECK SEL. B 7 + BASS PHONES TREBLE + T/P MUTE MUTE VOL. TUNE MEMO TUNE + FM MODE VOL. P. SCAN "MUTE" lights up and flickers. [. . . ] 200 mV Signal to noise ratio, IHF "A" weighted Phono(MM) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 dB Line(CD, TAPE, AUX) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95 dB Frequency response Phono(MM), RIAA, 30 Hz~20 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 dB Line(CD, TAPE, AUX), 20 Hz~100 kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]