User manual SHERWOOD VD-4502

[. . . ] VD-4502 Introduction UNPACKING AND INSTALLATION READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. FCC INFORMATION (FOR U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] · Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, replace both batteries at the same time. · The life of the batteries supplied is about six months but this will vary depending on usage. Notes · Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller. · Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference. · Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries. · Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation. · If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. 12 System Connections To accommodate a wide range of home entertainment systems, this player features numerous connection types for both audio and video. Please refer to the instructions on this and the following pages to determine the best possible type of connections for your system. Before Making Any Connections · Read the manuals supplied with your AV components. · Don't connect the power cord until you've completed and double-checked all audio and video connections. I Optical digital terminals The optical digital terminals are provided with protection caps. Before you connect a cable to a terminal, remove the cap and keep it safely. If you disconnect the cable, put the cap back on the terminal. I RCA AV connection color coding RCA-type AV connections are usually color coded: red, white, and yellow. Use red plugs to connect right-channel audio inputs and outputs (typically labeled "R"). Use white plugs to connect left-channel audio inputs and outputs (typically labeled "L"). And use yellow plugs to connect composite video inputs and outputs. · Push plugs in all the way to make good connections (loose connections can cause noise or malfunctions). · To prevent interference, keep audio and video cables away from power cords and speaker cables. AV Cables & Sockets Video Cable Component video cable Socket Description Component video separates the luminance (Y) and color difference signals (PR/CR, PB/CB), providing the best picture quality. (Some TV manufacturers label their component video sockets slightly differently. ) S-Video separates the luminance and color signals and provides better picture quality than composite video. Composite video is commonly used on TVs, VCRs, and other video equipment. Use only dedicated composite video cables. S-video cable Composite video cable Audio Cable Optical digital audio cable Coaxial digital audio cable Analog audio cable (RCA) Socket Description Offers the best sound quality and allows you to enjoy surround sound (e. g. , Dolby Digital, DTS). The audio quality is the same as for coaxial. [. . . ] · When the SCAN TYPE is set to PROGRESSIVE, the SCART VIDEO cannot be set to RGB, and vice versa. Notes · Some DVD-Video may be set to display subtitles in a different language than you selected. A prior subtitle language may be programmed on the disc. · Some DVD-Video allow you to change subtitle selections only via the disc menu. If this is the case, press MENU and choose the appropriate subtitle language from the selection on the disc menu. Preferences I DISC MENU Select the disc menu language. · · · · · · · · ENGLISH FRENCH SPANISH CHINESE JAPANESE GERMAN ITALIAN OTHERS I AUDIO Select the audio language. · · · · · · · · ENGLISH FRENCH SPANISH CHINESE JAPANESE GERMAN ITALIAN OTHERS To select other language 1. [. . . ]