User manual SHOPRIDER GK-73 DATASHEET

[. . . ] If you have any queries about the spare parts for the maintenance or any other concerns of your E-Bike, please contact your authorized dealer for assistance. Features 1 1. ON (I) -OFF-ON (II) Switch (Main Switch) 3. Controller (w/ Light) Tire Spoke Rim 6 8 7 9 11 15 13 10 12 10. Derailleur (Shimano Inter-3 Gear) 4 5 3 2 14 SUNRUNNER® is a registered trademark of the PMMC products. [. . . ] Check Motor and Control System Must check the motor and control system are performed well. General Inspection Check for brake shoes wear and replace as necessary. Check if the braking function is performed well. Check if the front and rear wheels are performing smoothly. Check if all connectors on E-Bike are firmly secured without any damage. If you have any questions after checking, please refer to the solutions for trouble shooting (page 16) or contact your authorized dealer for inspection and maintenance. Cautions for Riding Always follow the county's traffic rules while riding. Check the battery gauge if the charge is sufficient to keep the power assist for your riding. Do not keep riding your E-Bike if any problem has occurred. Refer to the solutions for trouble shooting (page 16) or contact your authorized dealer for further inspection and maintenance. Ensure to use the spare parts supplied by PMMC for replacement. Other Keys to Lifespan The lifetime of your E-Bike will be adversely affected by exposures to aggressive road conditions, dirt, rain, water or salt spray. Be sure your E-Bike, including the battery case, are protected well for transportation and store your E-Bike indoors when not in use. If the LED light is "OFF" all the time while charging: Check if the power connections are in good condition. If the LED light is still off all the time while charging, the battery charger may be malfunctioning. Please consult your authorized dealer for further assistance. If the LED light does not switch from GREEN to RED when the charging process begins: Check if the connection of the battery polarity is correct. Check if the connection between charger plug and charging port of the battery is correct. Check if the battery case is already fully charged. Check if the battery is functioned properly. The charging time continues for a long duration (Irregular): Check if the battery is out of order or aged. The battery overheats: 2008/4/30 9 Check the battery specification or consult your authorized dealer. Stop charging immediately and check if there is a problem with the charger or the batteries. Caution 1. Make sure the DC output connected to the battery to be charged is at the rated voltage, or it may cause unexpected danger or damage. [. . . ] Battery Case mounted on camera's stand Warm White LED Light on Controller Warm White LED Light on Battery Case 2008/4/30 11 Steps to fold the E-Bike 1 Refer to the instruction for Dismounting Battery Case to remove the battery case. 2 3 Loosen the clamp lever to remove the saddle. Note: Keep the battery case and the saddle in a safe place after removed from the E-Bike. 4 5 Lower the mudguard by loosening the tighten knob. Pull the trigger of the pedal and fold the pedal simultaneously. Repeat the same steps for the other side of the pedal. 2008/4/30 12 6 7 Pull out the safety pin from the locking hole. 8 Fold the front & rear frame assembly as shown. Insert the safety pin into the locking holes to engage the front and rear frame assembly. 9 10 Loosen and then lower the lever to retreat the pin to release the clamping of the handle bar. Keep the crank-pedals on the level while folding the handle bar. [. . . ]