User manual SHRINK POLYMER SYSTEMS HEASHRINK JOINT TO SUIT 2-4 CORE XLPE & SWA & PVC CABLE 0.6 TO 3.6KV TYPE SPA

[. . . ] INSTALLATION INSTRUCTION HEASHRINK JOINT TO SUIT 2-4 CORE XLPE/SWA/PVC CABLE 0. 6 TO 3. 6kV TYPE: SPA © DATE OF ISSUE:- 20. 01. 05 ONLY THREE CORES SHOWN FOR CLARITY X Fig 1 A B STRIP TO ½ LENGTH OF CONNECTOR A B X LONG SIDE SHORT SIDE 1. [. . . ] Position the Tubes centrally over the Connectors and shrink from the centre to one end at a time. Keep the flame on the move to ensure an even wall thickness. Sealants will be visible at Tube ends once fully shrunk. Note:- Heavy Duty Copper Sock is supplied as opposed to Cages for small Multicore and Power Joints up to 50mm2 OUTER SHRINK TUBE Fig 4 6. Wrap the Armour Cage around the joint gap and secure to the Armours at both sides with the Armour Clamps provided (Roll Springs if Copper Sock). Note:- User may need to apply Tape to the Cores to keep the joint profile down, particularly in the case of core crossing. Figure 5 shows Copper Sock secured to Armours With Roll Springs Fig 5 OUTER SHRINK TUBE Fig 6 7. Tape over any sharp points including Clamp Buckles. OUTER SHRINK TUBE Fig 7 8. De-grease the Cable Sheaths with the Tissues provided. Centralise the Tube and shrink from the centre to one end at a time. [. . . ] Before using, User shall determine the suitability of the product for his or her intended use and User assumes all risk and liability whatsoever in connection therewith. © UNITS P1-P3 GROVEMERE COURT BICTON INDUSTRIAL PARK KIMBOLTON CAMBS PE28 OEY TEL: +44 (0) 1480 861001 FAX: +44 (0) 1480 861002 EMAIL: info@shrinkpolymersystems. co. uk WEBSITE: www. shrinkpolymersystems. co. uk [. . . ]