User manual SHURE UB GUIDE SUPPLEMENT

[. . . ] ±45 kHz deviation, 1 kHz modulation) 0. 3% Total Harmonic Distortion typical Power Requirements U1, U2: 1. 5V AA alkaline battery recommended; Nicad battery optional U4: 90 to 230 Vac , 50/60 Hz Power Consumption: U4S: 9. 6 W min. , 13. 2 W max. Battery Life (Typical) U1, U2: 12 hours (with Duracell MN1500 1. 5V AA alkaline battery) E2003, Shure Incorporated 27D8670 (CC) Printed in U. S. A. Operating Temperature Range -20° to 50° C NOTE: Battery characteristics may limit this range Overall Dimensions U1: 92. 2 mm L x 64. 7 mm W x 24. 2 mm D U2/58:254 mm L x 50. 8 mm Dia. U2/BETA 87: 216 mm L x 50. 8 mm Dia U4S/U4D: 44. 5 mm H x 482. 6 mm W x 295. 3 mm D Net Weight U1: 175. 2 g without battery U2/58, U2/BETA 58: 375. 6 g without battery U2/87, U2/BETA 87: 303. 1 g without battery U4S: 3. 30 kg U4D: 3. 85 kg Certification U1, U2: Type Accepted under FCC Part 74. [. . . ] Pin 1: Tied to Ground Pin 2: Tied to +5 V Pin 3: Tied to Audio Pin 4: Tied thru 20k Resistor to Ground. (On instrument adapter cable, Pin 4 floats) Pin 1: Tied to Pin 3 and 10 k to Ground Pin 2: +5V Pin 3: Tied to Pin 1 Pin 4: Tied to Shield (Ground for Positive Bias) +5 V supplied to microphone cartridge 2 U1 Transmitter Output (Figure 1) Connector: Actual Impedance: Nominal Output Level: Maximum Output Level: Pin Assignments: SMC 50 +10 dBm +11 dBm Shell = Ground Center = Signal U1/U1H MIC JACK BOARD 2 4 3 1 2 4 20K 3 1 500 27 pF GROUND AUDIO 500 27 pF +5 V MICROPHONE ELEMENT NOTE: LAVALIER MIC TIES PINS 3 AND 4 TOGETHER; GUITAR CABLE DOES NOT. U1L (LEMO 4 PIN) MIC JACK BOARD 499 499 27 pF 1 2 10K AUDIO 27 pF BIAS 3 4 SHIELD FIGURE 1 U2 Transmitter Input Input Configuration: Actual Impedance: Maximum Input Level: U2 Transmitter Output Connector: Actual Impedance: Nominal Output Level: Maximum Output Level: Pin Assignments: SMC 50 +10 dBm +11 dBm Shell = Ground Center = Signal Unbalanced, active 20 k 3 Vp­p (0. 5 dBV) for 1% THD at minimum gain setting using 1 kHz signal. 3 U4S and U4D Receiver Input Connector: Connector Type: Actual Impedance: Nominal Input Level: Maximum Input Level: Pin Assignments: Voltage for Remote Power: Antenna BNC 50 ­95 to ­30 dBm +6 dBm (­20 dBm recommended) Shell = Ground Center = Signal 12 Vdc, 150 mA maximum Power Input IEC ­­ 90­230 VAC, 50/60 Hz 230 VAC, 50/60 Hz Network Interface 25­Pin D ­­ CMOS Logic ­­ IEC Standard ­­ ­­ 5V, 700 mA max. U4S and U4D Receiver Output Connector: Output Configuration: Actual Impedance: Nominal Input Level: Pin Assignments: Monitor Unbalanced mono, 1/4 inch 300 ­­ Tip = Hot Ring = Hot Sleeve = Gnd Yes Power Output ­­ ­­ 90 to 230 VAC, 5A IEC Standard High Z Audio Unbalanced 1 k ­­ Tip = Hot Ring/ Sleeve = Gnd Yes Low Z Audio* Balanced 30 ­­ 1 = Ground 2 = Hot 3 = Hot Yes Network Interface See Appendix See Appendix CMOS Logic See Appendix Voltage/ Current/ Phantom Power Protection? ­­ 5V, 700 mA resettable polyfuse *Output Level: Microphone Level = Line Level ­ 30 dB 4 FURNISHED ACCESSORIES Microphone Stand Adapter (U2) . 29B1577 OPTIONAL ACCESSORIES Instrument Adapter Cable (U1) . WA302 4-Pin Female Miniature Connector, TA4F (U1) . WA360 1. 8 Meter (6 ft) Receiver-Mixer Cable (1/4" phone to XLR) . WA410 7. 6 Meter (25 ft) Antenna Extension Cable . UA825 15. 2 (50 ft) Meter Antenna Extension Cable . UA850 In­Line Active Remote Antenna Kit (619 ­ 716 MHz) . UA830UB Antenna/Power Distribution System, 120 Vac . UA870UB REPLACEMENT PARTS Hardware Kit (screwdriver, mounting feet, cable clamps) . 90VL1371 Bulkhead Adapters for Front­Mounting Antennas . 95A8389 304 mm (12 in. ) Daisy­Chain Power Cord (120 V) . 95A8570 SM58 Cartridge with Grille (U2/58) . R158 BETA 58A Cartridge with Grille (U2/BETA 58) . R179 SM87 Cartridge with Grille (U2/87) . [. . . ] NOTE: Shure recommends that you maintain a 500 kHz separation between each receiver channel in the U4D dual channel receivers. Please contact the Shure Customer Service Department (1­800­434­3350) if you need additional information or assistance in frequency selection and setup. Compatibility Groups The Shure UHF Wireless System includes 10 groups of compatible channels. If you are using more than one receiver in the same area, we recommend that you set the receivers to different frequencies within the same group. Compatible Frequency List The following table lists the frequencies in each of the 10 compatibility groups. [. . . ]