User manual SIEMENS 4HT415X

[. . . ] Instructions for Use en 5600 050 388 (8206) en Index 3 4 5 6 7 8 9 Detergents . 10 13 14 16 17 20 20 21 Safety instructions . Getting to know your dishwasher Water softener . Filling the rinse-aid container Unsuitable dishes . [. . . ] temperature, water flow rate, etc. ) The water consumption values refer to water hardness value 2. End of programme The programme has ended when the pump noise is no longer audible and the programme selector has reached its initial position (12 o'clock position). Switching off the appliance Several minutes after the end of the programme: Switch off the main switch 4 . Turn off the tap Remove the utensils when they have cooled down. 14 14 en Interrupting the programme Switch off the main switch 4 . To continue the programme, switch on the main switch again. Note If the power supply is disconnected while the appliance is operating, e. g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Cancelling the programme Switch off the main switch 4 . To drain residual water out of the appliance, rotate the programme selector 1 in a clockwise direction to the drain symbol and switch on the main switch 4 again. Wait until a pump noise can be heard shortly afterwards and the programme selector has reached the initial position (12 o'clock position). You can now switch the appliance off. Changing the programme Switch off the main switch 4 . Set the programme selector 1 to the new programme (rotate in a clockwise direction only!). Check whether the detergent dispenser is still closed. Otherwise, refill with detergent. 15 en Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. This will save time and reduce problems. Therefore you should occasionally examine the inside of your dishwasher. Overall condition of the appliance Check the rinsing compartment for grease and limescale deposits. If you find any deposits: Fill the detergent dispenser with detergent. Start the empty appliance with the programme which has the highest rinsing temperature. Clean the door seal: Wipe the door seal regularly with a damp cloth and remove any deposits. Re-installation: Insert the filters and screw the filter cylinder tight. Dishwasher salt Check the LOW SALT indicator up with salt, if required. 27 . Top Rinse-aid Check the level of liquid in the rinse-aid container 30 . Top up with rinse-aid, if required. Filters The filters 28 keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. After each washing cycle check the filters for residue. [. . . ] When replacing the appliance, always connect a new water supply hose to the water supply. The old supply hose must not be re-used. Ensure that the fresh water connection is not kinked, crushed or twisted. Water pressure: Minimum 0, 5 bar ­ maximum 10 bar. [. . . ]