User manual SIEMENS CIELO 2

[. . . ] ENT doctors, audiologists or acousticians. Read and follow the instructions of this user guide to avoid injuries or damage to the hearing instrument. Symbols: Be aware of information marked with the warning symbol WARNING, CAUTION or NOTICE!WARNING points out a situation that could lead to serious injuries, CAUTION indicates a situation that could lead to minor and moderate injuries. [. . . ] Turn it on by completely closing the battery compartment. NOTE Do not use lubricant when you insert the LifeTube/ earmold, because it may clog the sound outlet. 11 8 Removing your hearing instrument Removing your hearing instrument: Hold the LifeTube/earmold between your thumb and index finger and carefully pull it out. You may find it helpful to lightly push your ear from the back. 12 Turning your hearing instrument on and off 9 Turn on: Fully close the battery compartment to turn the instrument ON. Turn off: Press the battery compartment downward to the first stop to turn the instrument OFF. Power-on delay Your hearing instrument is equipped with a "power-on delay" feature which can be activated by your Hearing Care Professional. This allows you to turn the hearing instrument on with an automatic delay of 12 seconds, so that you may insert the hearing instrument into your ear without experiencing unpleasant feedback (whistling). 13 10 Changing the hearing program How to select the programs Your CIELO 2 hearing instrument offers up to four hearing programs for specific listening environments. Select a program using the program button (only CIELO 2 S). Each time you press the program button, your hearing instrument switches to the next program, confirming each change with a beep. The number of beeps you hear coincides with the selected program. Example You turn your hearing instrument on. Your Hearing Care Professional can write down the personal program configuration of your hearing instrument on page 25. NOTE You can also use the ePocket remote control to change the hearing program. For CIELO 2 Life and CIELO 2 changing the hearing program manually only works with ePocket. 14 Volume control (only CIELO 2) 11 The volume of your CIELO 2 is controlled automatically and there is no need to manually adjust it. Should you prefer manual volume control, your Hearing Care Professional can program the hearing instrument for manual adjustment. Rotate the volume control with your index finger to select the desired listening volume. louder Your hearing instrument will not softer exceed your maximum volume. Signal tones can be programmed to indicate when the volume control limit is reached. Adjusting the volume further in that direction will then have no effect. NOTE You can also use the ePocket remote control to adjust volume settings. For CIELO 2 Life and CIELO 2 S changing the volume manually only works with ePocket. 15 12 ePocket (accessory) wireless remote control Your CIELO 2 hearing instrument allows you to use an ePocket to change the program and volume of your hearing instrument and to read out the instrument settings. For further information about ePocket, contact your Hearing Care Professional or refer to the ePocket user guide. NOTE In the event your hearing instrument can be controlled by another person's remote control unit (RCU), return your RCU and hearing instrument to the service department to change the transmission key. When operating the hearing instrument in T-coil mode, the wireless function may cause a pulsing noise. This is due to pick-up of the transmission signal by the hearing instrument T-coil. When your hearing instrument is in T-coil mode please use remote control with a distance greater than 10 cm (4 inches). [. . . ] If swallowed consult a physician or a hospital. Magnets may interfere with the operation of life supporting systems (e. g. Use a magnet only if not in doubt about the safe distance. The safe distance between pacemaker and magnet should be at least 10 cm (4 inches). [. . . ]