User manual SIEMENS DVF5311

[. . . ] en Brief Instructions: Dishwasher Short and handy: everything your dishwasher needs. . . Before using for the first time, read the Installation and Operating Instructions! Setting the water softening system * Find out the water hardness at your water utility company and enter below Read off the setting °dH 0­6 7­16 °fH 0­11 12­29 °Clarke mmol/l 0­8 9­20 0­1, 1 1, 2­2, 9 3, 0­3, 7 3, 8­6, 2 Setting 0 1 2 3 Quickly sorted and then select a setting ­ Hold down programme button B and switch on the main switch, then release the buttons. display flashes and buttons A and B illuminate (water hardness setting was set to 2 at the factory). [. . . ] PLOP! Select programme. Quick, economical or intensive . . . Overview of programmes This overview indicates the max. The programmes which correspond to your appliance can be found on your appliance fascia. Duration in minutes Intensive 70_ Normal 65_ Eco 50_ Quick 35_ Prerinse 450 J 9000 049 133 ( 8410) The programme data are values measured in the laboratory in compliance with Standard EN 50242. Deviations is practice are possible. Power consumption in kWh Water consumption in litres 105 1, 50 20 102 1, 30 20 140 0, 95 12 29 0, 60 12 13 0, 12 5 Switch appliance ON, off we go. . . Press main switch, choose programme. Close door. Additional programmes ** Increased flexibility . . . Upper basket cleaning . . . Only the crockery in the upper basket is cleaned Switch appliance OFF, everything OK. . . Signal sounds, open door. End-of-programme indicator flashes, press main switch. ** on some models Maintenance and care Strainers . . . Check, if required, clean Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . rinse under flowing water . . . Screw in filter system NOTE MARK! Cleaning the waste-water pump * * With some models ­ Ladle out water and remove filters ­ Unscrew cover (Torx T20) ­ Check area of fan impeller for foreign objects ­ Screw in cover and insert filters Spray arms . . . Remove blockages/deposits Pull lower arm upwards . . . Unscrew upper arm . . . Clean spray nozzles under flowing water (perhaps with toothpick) . . . Insert lower arm . . . Screw in upper arm Eliminating minor faults yourself . . . Fault Possible Cause . . . Self-help pays! Remedy Fault Possible Cause Remedy Spread out the utensils, avoid contact between the utensils. Follow manufacturer's specifications (detergent). Arrange the utensils so that the spray arms can rotate freely. Dishes not clean Residual water in the device Waste-water pump blocked Programme not yet ended Clean waste-water pump (see above). Close the appliance and wait until the programme ends (end of programme display lights up) or terminate programme (see Terminating the programme). Sand or grainy residues on dishes Utensils are situated too close to each other or on top of each other Too little cleaning product Unsuitable programme selected Spray nozzles blocked Filters dirty, not installed securely Spray arms blocked Appliance is not running / stops Check water supply Display lights up Supply fitting not open Supply hose kinked Supply fitting jammed or calcified Open supply fitting. [. . . ] ­ Close the door. Terminating the programme . . . ­ Open the door. ­ Press the two RESET buttons simultaneously (approx. The "signal sounds and the standby indicator illuminates". Arranging dishes correctly . . . Arrange dishwasher-proof dishes in accordance with the operating manual (without residual ash, wax, lubricating grease, ink, sticky labels; remove any large remnants of jam, milk products or food) and check that the spray arms can rotate freely. Switch off the appliance. [. . . ]