User manual SIEMENS EC745RT90A

[. . . ] This cooktop is for use with Natural Gas and Universal LPG EC645HB90A EC745RT90A Siemens - Electrogeräte GmbH Carl-Wery-Straß e 34 81739 München Cod. 9000532685 A www. siemens-home. com Content Safety considerations . Installation of cooktop into the kitchen bench . Changing the nozzles of the burners on the cooktop . [. . . ] If it does not come on, turn the control knob to the off setting and repeat the steps above. This time, press and hold the control knob for longer (up to 10 seconds). If after 15 seconds the flame does not ignite, switch off the burner and open a nearby window or door. Wait at least one minute before trying to switch the burner on. Safety system Fig. 15 Depending on the model, your cooktop may have a safety system (thermocouple) that prevents the flow of gas if the burners accidentally switch off. To ensure that this device is active, switch on the burner as usual and, without releasing the control knob, press and hold it down firmly for 4 seconds after lighting the flame. 15. Ignition sparker Thermocouple Switching off a burner Power levels Turn the corresponding control knob clockwise to the 0 setting. The progressive control knobs can be used to control the power needed, from minimum to maximum power. Setting Large flame Ú Control off Maximum capacity or aperture and electricity on Minimum capacity or aperture TM s Economy flame For double-flame burners, the inner and outer flames can be controlled separately. The available power levels are as follows: Inner and outer flame on full power. 16 Outer flame on minimum, inner flame on full power. Inner flame on full power. Inner flame on minimum power. Warnings It is normal to hear a slight whistling noise while the burner is operating. When it is first used, it is normal for the burner to give off odours; this does not pose any risk and does not indicate a malfunction; they will disappear in time. A few seconds after switching off the burner, it will make a sound (thud). This is not a fault - this means that the safety device is no longer operating. If the ignition sparkers are dirty they will not light properly. Clean them periodically using a small non-wire brush. Bear in mind that the ignition sparkers must not suffer any serious impacts. This is caused by the presence of dust in the atmosphere, spilt liquids, etc. The kitchen will become hot and humid when this gas appliance is used. You must therefore ensure that the kitchen is well ventilated: either keep the natural ventilation apertures open, or install a ventilation system (extractor hood). If using the appliance intensively for prolonged periods, you may require additional ventilation (e. g. by opening a window) or more effective ventilation (e. g. by increasing the cooktop's ventilation, if possible). If the burner flames are accidentally blown out, switch off the burner operating control knob and do not try to relight it for at least one minute. [. . . ] The (printed) symbols may be wiped off. 24 Service DO NOT MODIFY THIS APPLIANCE. Only authorized personnel from the Service Centre are qualified to work on the appliance. Sometimes certain faults detected can be easily resolved. Before calling the Service Centre, bear in mind the following advice: Possible cause Defective fuse. [. . . ]