User manual SIEMENS EQ 3

[. . . ] 43 Cleaning the drip tray and coffee grounds container . 36 Preparing coffee using freshly ground beans . 40 41 41 41 42 29 en Intended use 8 Intended use e s u dedne t n I ( Important safety information no i t amro f n i y t e f as t na t ropmI Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport. [. . . ] This time can be selected, with settings from 15 minutes to 4 hours possible here. Calc’nClean for at least 3 seconds. The factory settings are activated, the language selection appears. Touch the “V” button cappuccino and select the time. The following settings are possible: – after 15 min. (factory setting) – after 1 hour – after 2 hours – after 4 hours Confirm by pressing the “ok” button latte macchiato. The factory settings are activated, the language selection appears. Touch the “¾” button caffe crema to exit the menu. Press and hold % and Setting the water hardness It is important to set the water hardness correctly so that the appliance indicates in good time when the descaling programme should be run. You can check the water hardness using the enclosed test strip or by asking your local water supplier. Touch the “V” button cappuccino calc’nClean for at least 3 seconds. The factory settings are activated, the language selection appears. The factory settings are activated, the language selection appears. Touch the “¾” button caffe crema to exit the menu. Touch the “V” button cappuccino calc’nClean for at least 3 seconds. The factory settings are activated, the language selection appears. Touch the “V” button cappuccino and select the required language. The factory settings are activated, the language selection appears. Touch the “¾” button caffe crema to exit the menu. Strip in fresh tap water, leave it to drip and read off the result after 1 minute. The number of fields on the test strip that change colour indicate the water hardness level. Press and hold % and calc’nClean for at least 3 seconds. [. . . ] New water filter not rinsed according to the instructions. Rinse the water filter according to the instructions and then switch on. Immerse the water filter (opening up) in water until no more air bubbles escape; insert the filter again. Fill the water tank with fresh tap water. [. . . ]