User manual SIEMENS ER31120NE

[. . . ] The appliance's adjustment conditions are written on the label or the specifications plate. This appliance can only be installed in a well-ventilated place in accordance with existing regulations and ventilation specifications. The appliance must not be connected to a combustion product evacuation device. The supply cable must be attached to the unit to prevent it from touching hot parts of the oven or hob. [. . . ] This protects them from moisture which could collect under the work surface. Check that the voltage and power of the appliance are compatible with the electrical installation. The hobs are supplied with a power cable with or without a wall socket plug. Provide an omnipolar cut-off switch with a minimum contact separation of 3 mm (except for plug connections, if the user has access to it). Appliances with plugs must only be connected to sockets that have earth wires correctly installed. This appliance is type "Y": the supply cable can only be changed by the Technical Assistance Service and not the user. The cable type and minimum cross-section must be respected. Changing the gas type Installation of appliance The clips and the adhesive seal (underside of the hob) are factory-fitted: do not under any circumstances remove them. The seal ensures that the entire work surface will be watertight, and prevents water seepage. In order to fit the appliance into the kitchen unit, first place the hob in the correct position then loosen each of the clips so that they all turn freely (it is not necessary to completely undo them). Press the sides of the hob until it is supported around its entire perimeter. 3 Removal of hob Turn off the appliance's electricity and gas supply. Unscrew the clips and proceed in the reverse order to installation. Gas connection (fig. 7c-7d, and remove the control knobs from their respective housings. Use the disassembly lever 483196 available from our Technical Assistance Service. To release the front clips, apply the lever in the area shown in figures 8 according to the hob model. Never use the lever on glass edges which have no trim or frame!- To release the rear clips, carefully raise the entire glass panel and frame, as in fig. 9a): - Loosen the clamp screw to release the bushing by moving it backwards to access the main nozzle easily. - Remove the outer flame nozzle by turning it towards the left. - Adjust the distance of the airflow adjusting bushing L2 according to the value -Z- shown in table I. 9b): - Unscrew the part M3 from the threaded part M2; to do this, hold the threaded part in the opposite direction. - Disassemble the assembly of parts M2 and M4 from part M1. - Remove the inner flame nozzle M4 from part M2. [. . . ] Adjust the minimum ring setting by turning the by-pass screw using a flat head screwdriver. Depending on the gas to which your appliance is going to be adapted, see table II, carry out the corresponding action: A: firmly tighten the by-pass screws. B: loosen the by-pass screws until the gas flow from the burners is correct: when adjusting the control knob between maximum and minimum, the burner does not go out, nor is there a flame backdraught created. C: the by-pass screws need to be changed by an authorised installation engineer. [. . . ]