User manual SIEMENS ER326BB90L

[. . . ] You are recommended to contact the Technical Assistance Service to convert to another type of gas. This appliance has been designed for home use only. This appliance cannot be installed on yachts or in caravans. Before installing, you need to check that local distribution conditions (gas type and pressure) and the appliance's adjustment are compatible . [. . . ] 4) Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. These individual appliances can be combined with other identical appliances and/or with conventional hobs of the same make, using the joint accessory. The units next to the appliance must be made of non-flammable materials. The laminated covering and glue for adhering it must be heat resistant. This appliance cannot be installed above fridges, washing machines, dishwashers or similar. The end of the inlet connection point of the gas hob has a 1/2" thread that allows for: - fixed connection. - connection using a flexible metal pipe. In this case, it is necessary to insert the accessory (427950) and the watertight seal (034308) supplied between the manifold outlet and the gas supply. In this case, you must prevent the pipe from coming into contact with moving parts of the kitchen unit being inserted (for example, a drawer) and prevent access to any spaces which might become obstructed. If you need to connect the gas supply horizontally, our Technical Assistance Service can supply you with an L-tube (code 173018) and a seal (code 034308). If any connection is handled, check the seal. Danger of leaks. If the country's regulations allow, this appliance can be adapted to other types of gas (see specifications plate). The components required for this are in the transformation kit supplied (depending on the model) available from our Technical Assistance Service. The following steps should be taken: A) Changing the nozzles of the rapid, semi-rapid and auxiliary burners on the hob (fig. 6): - Remove the pan supports, burner covers and diffusers. - Change the nozzles using the spanner provided by our Technical Assistance Service (code 424699), taking special care to ensure that the nozzle does not fall when it is removed from the burner or when fitted. Ensure that it is completely tightened in order to guarantee the seal. Primary air adjustment is not necessary with these burners. B) Changing the nozzles for doubleflame burners (fig. 7): The glass panel and frame are fixed to the rest of the hob using a clip mounting system. The following steps must be taken to remove the glass panel and frame: - Remove all the burner covers and pan supports. - Release the front clip fixing the appliance to the kitchen unit by removing the screw. - Loosen the screws on the burners, fig. [. . . ] It is important that all the seals are refitted to form an electrical seal. These devices are essential for the correct operation of the appliance as they prevent liquids and dirt from entering the appliance. In the event of a malfunction, change the whole tap. After finishing, the sticker indicating the new type of gas must be placed close to the specifications plate. 3 EN 30-1-1 3 / ( 4) : " EMSD Approval GTXXXX" ) 1/2" - - (427950) (034308) 4a ( 173018) 0343084b ! [. . . ]