User manual SIEMENS ER39553EU

[. . . ] Operating, installation and caring instructions ER39553EU 1 GB Operating, installation and caring instructions page 02 English Dear Customer, We thank you and congratulate you on your choice. This practical appliance, which is modern and functional, has been manufactured from top-quality materials which have been subjected to a strict quality control during the entire manufacturing process and have been carefully tested so that they will meet all your cooking needs. We strongly advise you to read through these simple instructions, so as to ensure that you get perfect results from the moment you first use this appliance. This booklet contains important information, not only on how to use the appliance, but also on maintenance and safety. [. . . ] Particular care must be taken to provide suitable means of ventilation. 8 Installation (for the installer) Installation must be made by a kitchen installation expert. Note: If you intend to have the gas hob welded into a stainless steel worktop, for safety reasons and in order to fully maintain the requirements of your Siemens warranty, we recommend that this type of installation be done solely through our designated partner: Bautek. The countertop must have a thickness of 30 mm and a maximum of 40 mm. Do not use liquid silicone to glue the hob to the countertop. The furniture below the countertop should have an opening for passage of the gas pipe and electric wires measuring at least 50x50 mm. Any eventual cabinet, resting on the worktop, at any of the two sides of the hob, and the upstand on the back of the hob, each must be at least 50 mm from the edge of the hob itself. In case of elements sold complete with cabinet, the instructions for installation of the cooker hob are provided in the manual for the cabinet. Apply the sealing gasket along the edge of the opening taking care to overlap the joints (picture 1). Fit hook B in angle iron A welded on the unit (picture 2) taking care to block it in the holes provided, depending on the thickness of the countertop (30 mm, max. Turn tab C and position it under the countertop, then tighten screw D. Trim, if necessary, the part of the gasket extending beyond the cooker hob. Picture 1 Gasket Picture 2 9 Picture 3 10 Electrical connection Prior to connection check the voltage and total output on the technical label affixed to the appliance. It is obligatory that this appliance be earthed. When connecting the appliance, ensure the earth wire is connected first and that all wires are connected to the correct terminals. Particular care must be taken to ensure leak proof connection. The maximum permissible length of the gas connecting pipe is 2. 5 m. This safety gas tube must be routed in such a way that it is not fed through hot areas and does not come into contact with any hot parts of the appliance, e. g. Installation of the tube must ensure that it runs freely and that it cannot come into contact with any movable parts of the kitchen cabinets, e. g. a drawer. 14 Caution Only switch on the circuit breaker or main switch once the appliance has been installed. The appliance must be installed in the furniture in accordance with these operating, installation and maintenance instructions. It is important to note that we shall accept no liability for damage which is a direct or indirect result of improper connection or installation. The appliance must always be disconnected from the mains before repairs are carried out. If repairs are needed, never open the appliance yourself, but call our after-sales service. [. . . ] - Make sure that the electrical connection has been done correctly. - Place the different pieces in the correct position. - Clean the grooves on the burners' gas outlets. - Replace the gas bottle with a full one. [. . . ]